Recent content by redngreedy

Interesting. I have the same amp, but I use the same side terminals. There shouldn't be a difference correct?

It was the gain setting. Plays fine now, and not clipping. On a side note, I guess it's time for a bigger amp. Thanks again for all the help.

10-4. Thanks for all the help guys. I will update this evening, or first thing in the morning.

Now that I know that, I'll reset the gains this evening. One more question, I believe the amp can handle 4 volt pre outs, but the hu is 5 volt. How do I go about setting the sub level, and gains and be safe?

When I set the gains, I was around 70% of hu volume.

I used 50 at 0db.

Well if all else fails, I do have 2 extra hu's at the house. I shall try that as well I guess.

Subs are wired like so. When I set it up with the DMM, I set it right at 34 volts, which it called for 34.64, so I backed it down a tad. No, it's not clipping at low volumes, just when I get to about 85% of the hu volume.

Amp is not bridgeable. It uses one channel, and is stable at 1 ohm.

Wiring is fine. I think I have an extra set of rca's laying around I may try out.

Thanks, and yes, **** noobs. They act like they know everything

For starters, I have 2 brand new Fi q 12's (dual 1 ohm voice coils) with the BP option. I'm running a JBL BP 1200.1. Stock electrical, except battery. Running the q's in a sealed box with about 2.5 cubs total. Power and grounds are all 4 gauge. Wire for subs is 12 gauge. I'm having a problem...

Hello all. Just dropping in the intro section to say hi. Been a frequent reader, just never signed up.