Recent content by Razorfist

I bought 2 100 uF Caps today and the're HUGE!!! I paid € 5.24 each for them ($ 4-5) but that's not really important. I haven't placed them in the car yet but thanks for the help so far :P

How about taking some cardboard as a template? just take little pieces off untill it fits. The plastic-thingie is very creative! I never would have thought of that! It will actually work quite well if you draw a line where the board should come so you won't have to start all over if the tape...

I would like to filter the lowest tones out of my front speakers. I guess that would be 200Hz and lower. For this I need a capacitor but wich capacity? It's for speakers with an impedance of 4 Ohm. And I read about first order, second order and so on but is there a clear difference? Are first...

I've got both! Suzuki Alto 2001 € 255 headunit (JVC Chameleon) € 35 front speakers (JBL GTR4002) no amps, no rear yet Beat that!

Thanks a lot guys (and girls maybe ) I know what I'll be doing after my exams next week :P

Thanks! and what would be a good material? Everyone says 18mm (about 0.7", I use metric myself ) thick MDF because it's really stiff, but I think that's a bit "overkill" for these small boxes...

Wow! I didn't even know those existed! But do you know the Suzuki Alto? It's probably the smallest car around! (cheap though!) With the drawn model above it would fit right in, taking as little of the trunk as possible. I need to have some room left for shoppings and things like that...

Is it possible to put 6"x9" drivers into a box? I currently drive a Suzuki Alto (yeah laugh! go ahead ) without anything to mount my speakers onto. Is it possible to make a box, somewhat like this picture? It's going to be a little bit bigger, approximately 50cm wide (err... about 20" that is)...

Funny how those manufacturers always try to fool us