Recent content by PurpleDiesel

Problem fixed! after all this time I had no clue it was backwards to begin with lol How I resolved the issue: Left the headunit rca as they were * reversed the headunit > bit one inputs * left everything else the same * Reset all features on the bit one and ran the initial setup all over...

I figured it out my headunit is backwards in order to have the correct balance on the bit one. If i fix the balance at the headunit everything else that follows is backwards

Correct TY I remember now. My Headunit Balance is Reversed because no matter what combination I tried I always got one source that was incorrect. Head unit balance = backwards bit one software L+R = correct bit one controller balance = correct sound output = backwards

UPDATE: Problem fixed! after all this time I had no clue it was backwards to begin with lol   How I resolved the issue: Left the headunit rca as they were * reversed the headunit > bit one inputs * left everything else the same * Reset all features on the bit one and ran the initial...

Thanks for the advice. I'm going to give it a go and hope for some improvements

interesting. 99% of the time i'll be listening to my ipod via the ipod adapter for this head unit All in all I "should" have a cleaner sound regardless by going optical vs rca direct swap correct?

Running a headunit with Digital Optical Output into a External Processor   I read somewhere that I only get digital signal with CD's and not ipod/radio/etc. How is this possible if the optical cable is the only thing sending signal. Do I have to now use CD's only in order to enjoy the high...

Hello. You might want to keep calling and see if any one of the three guys can walk you through it. 1. The main thing was to reset the software to factory defaults through the settings. 2. finalize to bit one 3. turn off ignition and bit one 4. turn it back on and run through the INITIAL...

THANK YOU!!! I didn't see that number listed on the site at first only the email that didn't work they resolved my issue it seems that there is a glitch built into the software that I would have never figured out on my own.

I tried to send an email and it says FAILED TO SEND. Please contact our administrator another way I tried to send an email and it says FAILED TO SEND. Please contact our administrator another way

I've tried this and not one has a clue they just sell them. I looked for tech support number but they're all out of the country

update i'm a few minutes from scrapping the whole bit one   1. SETTINGS SAY SAVED SUCCESSFULLY BUT ARE ERASED THE SECOND I'M DONE TUNING 2. I HAVE NO VOLUME WHAT SO EVER... DEAD SILENCE

Firmware issue?

Update: Technical support informed me that the Newest Bit one software had a glitch. After a combination of factory resets I have resolved the issue and now have full functionality.

You get what you pay for get a quality line driver for the cleanest output