Recent content by pluto

JL 350 for front and rear x's. JL 250 FOR A 10" sub. All run off of 1/0 wire.big 3 already done plus multiple other grounding points. Thanks

Will do. Looks like monday will find me trying to track this down.- could my amps be the cause of this and what do I specifically look for .Thanks

Thanks man, you are correct about that. maybe my speaker wires have come off and are grounding out . Any other ideas. Thanks

voltometer showed low voltage so I had the alternater changed and it did the same thing untill I took the fuze to my system out. Now my truck runs fine with my system completely shut down. Does this sound like a grounding problem. I havent really looked at it closly yet. I want your opinions as...

Anybody?????????

Have a problem with fader control. everything has worked fine for last six months until today. Fader is set to run front speakers with a little rear fill. Now all speakers play with it still set for the front speakers. When I turn the fader for the rear speakers all speakers quit working. I...

If you really want to insure that no water will get to your speaker------- check and make sure that the rubber located at the base of the glass has not dry rotted and cracked. This is a simple fix and all you do is go to a body shop or your local dealer to order the replacement part. The rubber...

Sorry I did not see that you posted a link for a charger off of E-bay. Dont buy that piece of crap. You get what you pay for. A 10 amp charger will bring a deep cycle back much quicker!

Since that battery is a deep cycle, I would go to West Marine and buy a ''GUEST PRO''. This is an 10 amp charger that will quickly bring the battery back to a full charge. It also charges the battery in three stages and will top it off and you won't have to worry about it overcharging or boiling...

bumpity bump----- ANYBODY?????

How do you check a channel on a jl300/4 to see if it is bad.Is there any simple checks that I can perform to see if it is the right front channel or posibly a problem with the headunit.

When I bought my headunit from Best-Buy they installed it. I had to carry it back because the front right speaker was not putting out as loud as the left front.My ride is an 1993 F-150 extended cab. The Head installer looked at it and said that this year truck was different and the wiring...

The door panel's are hard plastic with a fuzzy materialon the outside. I want to mount my tweeters in the panels and I dont want to mess it up.Can you tell me how the correct is way to get a good clean cut. I have a dremel but dont know what the best tip is to use with it. Idont want to tear the...

the vehical is a 93 F-150 . the power for my amps is running down the right side by the door. Just wanted to know if there was anything behind the dash electrical that would interfear with the signal.Think it will be ok to run it behind the dash to the left door by the parking brake then...

Iam hooking up my rca's to the back of my headunit and was wanting to know how the correct way is to run the cables in the dash. do you go left towards the wheel or right towards the door or straight down? Does it really make a difference?? 1st install and I want to do it right the first time.Is...