Recent content by phoenix808

  1. P

    polk momo components

    i have the mm5s and they have great midbass. they're not sealed either. in fact, when my subs were out of my 4runner (stolen), i was pleasantly surprised at just how much mids and bass they put out. dunno about the mm6s, but if they're like the 5's you'll be good to go!
  2. P

    amp rack wiring/quick disconnect?

    hey all. im planning on building an amp rack, and would like it to be quickly removable (all theoretical now, no real clue of wiring yet). i would like to put my 2 amps and my cap in there, but didn't know if it was possible to have a capacitor and still be able to quickly remove the rig...
  3. P

    Newbie question: Tuning box?

    not to jump in on this person's thread, but how would their question apply if you had 2 eD k12.44s, vented?
  4. P

    out with the MTXs...now where to?

    would powering 2 ed 10k.44's with a 500.1 amp be ok? or could i not wire those to get a 4 ohm load? sorry for the dumb questions.
  5. P

    out with the MTXs...now where to?

    I have 2 MTX Thunder 6000 12s...and they **** (go figure). So, I'm looking to get a replacement bass solution. My amp is an RF 1001bd...but i run it at 4 ohms (500w) 'cuz that's all my electrical system can handle right now. Any suggestions on what to get? 1 12? 2 10's? My main objective is...
  6. P

    where'd my L7's go?

    thanks for all the input guys. i'm sure it was my electrical system...i was pulling *way* more than my wimpy 60amp alt could handle. unfortunately, i dont have the dead prez to fork over for a new alt right now, so back go the L7s and i'm stuck with 2 MTX T6000 12's for now...
  7. P

    Polk MOMO? Infinity Reference?

    I have a set of polk momo's mm6's. I love the sound of them. They are bright on the highs (as stated above, Infinity highs are a bit softer), but that's what I prefer. I definitely found them miles beyond other speaks i listened to...but that's just mho. happy shopping.
  8. P

    amp suggestions?

    i currently have a RF 500.1 amp...but crutchfield told me (i know, i know) that i'd blow those subs with that amp. but at 4 ohms it puts out 500w... would it make a diff. how the subs were wired? they go to a single terminal cup... thanks for the input...
  9. P

    amp suggestions?

    anyone suggest a nice amp to power 2 MTX thunder 6000 12's, 4ohms? I'd really appreciate the input...
  10. P

    where'd my L7's go?

    i have an RF 1001bd @ 2ohms pushing 2 Kicker L7 10's at 2 ohms. The problem is, the bass is fine for a bit (enough to eq them and set the gain), but after short while, the bass just goes away...i mean, it's still there, but *very* faint and not at all what the subs should sound like. think it's...
Top