Recent content by Paul73

I've heard others say that it isn't accurate as far as tuning freq. is concerned but I haven't found that to be the case and I've used it for at least 5 box designs. As far as more to it, yeah there is a lot more to it. Most manufacturers suggested box volumes are just that, suggestions. They...

M3 is a great all around daily/street beat sub, that is only slightly quieter than an L7(with same power) but will sound 100x better. L7 is good for SPL only imo.

Sounds well worth a look.... You get em from Madisound?

http://www.partsexpress.com/pe/pshowdetl.cfm?Partnumber=264-834&FTR=264-834&CFID=11128600&CFTOKEN=92870294 These. Great tweet for the money, very smooth. Laid back but detailed.

Sweet! Thanks, good to know. I'm actually looking for another set of tweets right now....I love the TangBands sound wise, but they can't handle power for ****. I am running Mpyre/Extremis mids right now so I need a twet that will get fairly low and handle some power. No small feat for a small...

Active or Passive? How low will those Neos go?

I could only see this scenario being possible if your voltage regulator were to go bad at the same time as the blown fuse That's kinda the regulator's job....regulate voltage output by the alternator

Ok thanks. What about two batts? Will that be enough, need more, or could I get by with one?

I am planning another build and would like you guys opinions on electrical upgrades, Car is a 1988 Thunderbird Turbocoupe. System will include my Sundown 1500D running two Avalanche 15s @ .5ohm (this particular amp benched 2200rms at that load) Sundown 100.2 running unknown 8s in front floor pan...

Agreed Check out New Yankee workshop for router table plans. If Norm Abram designed it, you can bet its ****ed near perfect for real wood working needs,

Brian, how will these compare to the Ava?

DRZ-9255 \thread

Audiobahn /thread