Recent content by panteramatt

I believe its a ground issue. I ran the ground wire through the firewall and to another ground that was attached to and electrical box under the hood. The new amp wouldnt power on til I removed the screw the ground was attached to and cleaned it. All the gains were set properly and theres an...

I have a voltmeter

Im using 2 rca splitters on the amp. Could they be a problem?

What shouldn't matter?

No I used the same ground I used for the other 2 amps but it wouldnt turn on the SS amp. Maybe their too finicky. Im gonna make a better ground for this one.

SO Ive gone through 2 amps in my bronco. I have them mounted under the dash as their very small. One RF pbr300 and a kenwood. Now I just hooked up a soundstream but for some reason the ground wasnt strong enough but I got it working. I had them mounted with screws through the floorboard. Could...

Heres a review with a similar setup: This amp runs perfectly, and stays cool even under sustained load. I see that many people think the two speaker connections means this is a two channel amp. Not so, Pioneer did this to make hook-ups easier for the consumer. You can run your subs parallel in...

How long does it take to break these woofers in?

The bass is decently loud but doesnt hit low and when a long bass note hits, itll hit it but cut off pretty fast. I have my low pass at 100db but the amp has no high pass.

I wondering if I should turn the gain up a little. I set it with a multimeter to 16v and its about 1/8 way up on the dial. I can play it loud for a while and the amp is cool.

Pioneer GM-D9601 amp and sundown sd3 D4. I have a 250 amp alternator with 1/0 wires splitting to 4 gauge wire going to 2 amps.

Yes all the electrical has been upgraded and yes I'm sure it's wired @1ohm. It's a pioneer amp

All my electrical has been upgraded in the truck and yes I'm positive it's wired @1ohm. It's a pioneer amp

1 ohm

I installed 2 sundown sd3 10's behind the seat of my 2006 f350. The sealed box gives each sub 1cuft each and each one is getting a true 600 watts rms. PRoblem is they just dont hit very hard at all or get low. Barely moves my mirror. Now I know the box want built for the subs and its probally...