Recent content by PaLiAcH

bump

the head unit is set to 80 hz low pass filter and the the fade is normal (about 1.5 notches toward the front) the amp is set at low pass filter as well. when the volume is up the subs hit hard as set by the amp, and when the volum is lowered, lets say to halfway, the subs will stay on at the...

any other possibilities?

bump

could cheap rca's do anything? or does that just deal with noise and such? (ive got the old skool monster cable bright purple rca's -- the one with the remote turn on incorporated in the center of the rca's, which i just ripped apart to separate the power from sound)

grounds are all solid... and that would be a strange coincidence to occur both times with two different car setups... keep em coming... thanx again!

Hey fellow audio nuts, did some reasearch under the search forums, but couldn't find anything. i finally installed my old head unit in my car (a sony cdx c7000x) with a single 10" Kicker Comp VR 4 ohm sub with a 200w mono amp. now my problem is that the subs start hitting only at about 3/4...

i was just re-affirming.... just to prove youre not a nut case... hehehe

i wanna say it comes with a little crossover box...? im looking into the alpine type x 6.5's... http://iweb.alpine-usa.com/pls/admn/item_info?p_item_name=SPX-17MB&p_category=80&p_subcategory=155&p_main=10&p_more=y and the alpine type x 4" 2 way component set.. or am i...

passive crossover? im usin a regular 2 way component set and a component 6.5" for midbass...

checkin out specs, i see that i will get more power by getting 2-2 channel amps as opposed to getting one 4 channel amp obviously i would spend a lot more $$$ by trying to get comparable power out of one 4 channel rite?

for a 3 way component setup (tweeter, midrange, midbass), how many amps are needed? do i need one 2-channel amps for the midrange and tweet, and one 2 channel amp for the midbass? or can i use just one 4 channel and and power all of them? thanx for helping a newb out!

the secret to spray adhesive is to spray both the wood and vinyl, then wait about 10-20 seconds to let the adhesive get tacky... then apply vinyl to mdf... im in the upholstery business... i work with spray adhesive all the time

the place where the mid/tweets are gonna go is already a "pocket" type enclosure... and i will be glassing the top... thats what the high quality blue colored photoshoppin skills are for and for the woofer, it will be in the stock location with an IB and dynamated.... is that wat ur saying?

2001 Mustang Bullitt