Recent content by Paddywad

May have a solution for you if you are willing to spend some money. Kenwood has some new products that can incorporate what you are asking. Here is a scenario, http://www.crutchfield.com/p_113KOSCV10/Kenwood-KOS-CV100.html?tp=119, use that inconjunction this...

Sounds like you paid them to do their work. You paid $60 for losing a harness, which I bet is still there, and you say that you worked two hours at $10 an hour. They profit from you majorly not to mention how much they charged the lady in the van for the install as well. By the way, did you...

Check out this amp: http://www.concept-intl.net/proddetail.asp?ID=305&ProductLine=Amplifier

Where abouts are you in Greer? I'm only twenty minutes away.

I would upgrade your ground wire/connection to match that of your power wire. Don't connect the capacitor, but do check your voltage.

To the OP if you have a local Hobby Lobby, go there and get the following: Extreme Power Instant Adhesive ($4.99) SKU: 238410 (CA Glue) Extreme Power Accelerator ($3.99) SKU: 238766 Use the trick that Yunvme666 mentioned along with the mentioned products, and all should be kosher. Did it to...

I'm still rocking my Clarion ProAudio 4x6 plates that I purchased back in 1998. Have been in and out of four S10's. The SRC4695 resemble what I have, but mine are black not silver. Very good speakers.

Look at Image Dynamics ID8D2 or D4 for a more low wattage SQ setup. http://www.imagedynamicsusa.com/tech_page.php?name=ID8D2%20V.3&type=sub&id=id

PPI flat piston subs from the 90's.

Bump the subs, I would take the amp. It cost around $180 when new a few years ago. Very trustworthy amp.

^^^^^ Beat me to it. Here's thread that talks about the front usb and the KTX-100EQ imprint kit. http://www.diymobileaudio.com/forum/showthread.php?t=22136 Post #7 gives the use of the front usb.

Don't know if this helps, but I was searching Ebay and found this: http://cgi.ebay.com/15-ARMAGEDDON-BY-KOVE-WOOFER-500-W-RMS-2-VOICE-COIL_W0QQitemZ360000456283QQihZ023QQcategoryZ3292QQcmdZViewItem FYI, I had a pair of Kove's 6.5 components back in the day, and I really liked how they played...

My step-daughter's 2003 Mitsu Eclipse Spyder w/ the infinity system. Not fun at all.

You can see mine with 20% on driver/passenger windows, and 5% on the back windows and across the windshield in the post your ride thread. http://www.caraudio.com/forum/showpost.php?p=3624218&postcount=3145

The maxima FTW. It's basically a 4-door sports car.