Recent content by oni

Not really. I have a 2008 ES and the seats should all fit the same for an 08,09,10. I'm just surprised the 2010 DE didn't get the 60/40 seats like most of the other ones have. Might need the ES to get the seats, but I couldn't imagine they'd cost too much at the junk yard.

Great guy. I bought a used US Amps Merlin MD1D from him. Fast shipping after paypal was confirmed. There was an issue with the shipment on UPS' part, but Doola was very fast about getting it fixed if UPS wasn't cooperative with me. But thankfully they fixed it for me without him needing to get...

resolved! info @ http://www.caraudio.com/forum/showthread.php?p=6040133#post6040133

... FINALLY WORKS! I rewired the LOC to the rear speaker wires past the factory amp instead behind the deck and it all works now! Apparently the radio puts out a signal no matter what, and the factory amp is what controls the volume. So that's why I was getting output at 0 volume. All I have...

Well, my amp ground is good for sure, but I don't know about the LOC ground. I'll redo that one and see what happens.

Well, I can't get an aftermarket HU for my car yet. I don't have the money to redo the components I wanted to do and my car has a factory Amp that is turned on with a CANBUS system and there isn't a harness for it yet. Once there is, I will be putting in a Touch-Nav, but until then, this is my...

Supposedly the Hifonics BXi --10D do rated power. the --06 adn --08 lines don't, but they are still a decent bang for your buck. Planet audio I have no experience with.

OK, so I have my new amp and got everything installed. Now I have a new problem. When I fire everything up, my sub is playing with the radio volume at 0 and amp gain all the way over at 8V, but it stops when I push the button to turn the radio off and the rhythm changes when I change songs. When...

I liked my brutus when I had it. But I didn't know a lot about many other brands. But it did randomly die for some reason I haven't figured out yet.

I still don't know much about box design but wanted to know if/how much the output would be affected on a ported box if you were to change the overall dimensions but keep the overall volume/tuning the same.

List the Specs of the Amp... i.e. The RMS output at each ohm load it is rated at Also I assume your CVR is a dual 4 ohm correct? need more to go on

Any of the Fi subs (Q, Bl, Btl) can take a lot of power and move a lot of air for a 10. Those subs, in that order, are for SQ, SQL, SPL, so depending on what you're looking for, check youtube, there's videos of all in single 10" setups iirc. Now when my MD1D comes in, I'll finally be rocking my...

Only if it can handle that much power

kk, and I assume the plans are before displacement?

Also was looking for suggestions for that sub if anyone had a better volume/tuning to suggest