Recent content by NYCJEEP

I thought less port area is more prone to port noise? I would assume there is a limit to how big you can go before encountering problems or down sides...

So you think a single 6" port would be more susceptible to port noise compared to two 4" ports? The only reason I want to use a 6" is because it would fit better between my 2 subs...I only have 40" wide to play with and right now the 4" ports are crammed in between...

Anyone here have any experience using a single 6" port in place of two 4" ports for a standard ported enclosure? I am considering it for my 2 IDMAX 12s...

same thing when fading left to right. I am going to swap the amp in place of my sub amp and see of for some ungodly reason it stops when using the power and ground wire for my other amp, though all power and ground wires are coming from the same dist block...sometimes in can be the stupidest...

Thank you all for the responses. I have checked the voltage at the ground and power terminals on the amp in the past and it seemed fine. If i disconnect the speakers while the sound is cutting on and off the red lights go from solid back to flickering again. I am going cazy over this because...

Hello to everyone here. I have s clipping problem with an old RUBICON 604. Every time I turn the volume up on my Pioneer avh6600dvd head unit (especially on dynamic music) the clipping lights flicker which is normal. However, at peak notes the lights turn solid and the music cuts on and off...