Recent content by noonej21

bump

Just got my new SS RL-i 10 and I am looking to move my older Eclipse as I no longer plan to use it. Model is the SW 8122.4, single 4 ohm voice coil. Speaker was bought brand new in box last year and has only been run off clean PPI power provided by a Powerclass PC2150. Subwoofer is in perfect...

Not really, just looking to move the stuff that I am no longer using

bump

bump

Looking to move some of my extra older equipment that I no longer need/use. http://i197.photobucket.com/albums/aa269/noonej21/IMG_1617.jpg PPI PC2150, works great just took it out and replaced it with a Pro-650 that will run my entire system. Comes with both plugs and original manual. Does...

I posted this over on the TC Sounds forum, but figured I might a get a few more hits over here. Just wanted to get an opinion on which of these two would better suit my needs(current equipment). Currently I am running an Eclipse 8122.4 in a sealed enclosure off a PPI PC2150, which has been...

The "pop" was a lot louder when I turned the car off or when I would use some of my decks functions(track skipping, source selection...) than it was when I would first turn the car on. The odd thing is that I switched out my amp with anther PPI that I have. PPI PC1400 and there was nothing...

I know this has been asked many times but my situation seems a little different. Current setup is a PPI PC4100 running factory speakers(an upgrade is soon to come) and a PPI PC2150 powering an eclipse 8122 at 4 ohms mono. As far as grounding I have a 4 gauge wire connected to the rear set belt...

Amp is only stable to 4 ohms mono(1400x1). Take you DVC 4's and run them series-parallel(run the coils on each sub in series to make an 8 ohm load then run both subs in parallel to get down to 4). A manual for the later generation of that amp is here(PC21400) http://www.phy6.net once there...

I have an 8122 SVC and it is a 4 ohm coil. Where are you getting the 3.1 ohms number from?

From what I have been told, the PPI amps do not handle running at lower that rated impedances. They get very warm and eventually go into protect mode. I think you are stuck. By the way nice set of amps, I have the same ones plus a PC2150, I would love to get a PC2350 just to have but they are...

Thanks for the help, I had taken one cut at the design and came very close to what I wanted the end result to be. I designed this with an "L shaped" slot port so for total length I measured from the front of the port opening (port opening is on front of enclusure with sub) to a point that was...

I am in the process of designing my first ported enclosure for my Eclipse 8122. Based on the suggestions from many members of the board I think I am going to shoot for a design around 1.75 ft^3 @32 (if this sounds bad for this speaker please let me know, I will be giving it around 600 watts). I...

While I will freely admit that my knowledge of the finer details of how speakers work is not as vast as many's the original poster asked if the subs would sound different with that particular amp. My response was that they would probably be louder. I still cannot see, maybe I am completely...