Recent content by namomaitreya

  1. N

    Advice on wiring method for this setup.

    Yea, thats the image i was using. Do I need to run my + and - from different voice coils? Or can the wire go from the same voice coil to the cup? And then can I just run a wire connecting the two cups together and then run a wire from the center of the wire connecting the cups?
  2. N

    Advice on wiring method for this setup.

    I have two Memphis 12" 15-PR12D4 DVC 4-ohm. And a Memphis MC 16-MC1.500. The speakers are 250/500 and the amp is capable of 125W@4ohm 250W@2ohm and 500W@1ohm. I was planning to wire them @1ohm. By attaching the ++ and -- on each speaker and taking a second wire from the +- from one voice coil on...
  3. N

    Subs get loud, but don't get that feeling.

    Looked up my enclosure recommendations on Memphis' website. Thought I'd list them here in case anyone could comment on the difference between the pre-fab box and the recommended dimensions. 15-PR12D4 x 2 in Vented Box Minimum : 3.00 / 45 / 12.5 x 2.5 x 13.75 Optional: 3.80 / 35 / 12.5 x 2.5...
  4. N

    Subs get loud, but don't get that feeling.

    Thanks for all the replies and comments thus far. I've really got a lot to work with. I figured it was either my crappy box, my crappy "premium factory HU", or the Amp.
  5. N

    Subs get loud, but don't get that feeling.

    I planned on doing the deadening as well. Possibly going to put in a custom HU at a later time. Do you think that the amp I have matches those speakers alright or to low power?
  6. N

    Subs get loud, but don't get that feeling.

    yea sounds like crap right now but i know its capable of more.
  7. N

    Subs get loud, but don't get that feeling.

    need to get it down to 35 or so right?
  8. N

    Subs get loud, but don't get that feeling.

    12.75Hx2.75Wx13D straight to the back of the box.
  9. N

    Subs get loud, but don't get that feeling.

    I don't see any branding on it. POS apparently.
  10. N

    Subs get loud, but don't get that feeling.

    12.75 inches high by 2.75 inches wide
  11. N

    Subs get loud, but don't get that feeling.

    The subs are facing towards the rear of the car. The box is a pre-fab. Dimensions of the box are 15Dx15Hx35W. Rectangular box no slant. The port is in the middle going from top to bottom.
  12. N

    Subs get loud, but don't get that feeling.

    I have two 12" Memphis 15-pr12d4 in a ported box and a Memphis Class AB 16-pr2.75. Upgraded to factory installed JBL system and speakers(instead of stock). In the trunk of my 09' Corolla Type S. The box takes up a good portion of the trunk not leaving to much room. I have the amplifier...
Top