Recent content by MooreMunky169

Alright will do thank you for all the help

The Amp is set at HPF 60Hz and the receiver is actually set at HPF 80Hz with a -20dB/Oct slope. So far with the blow speakers the cost is adding up. I just don't want to damage the new 6.5" that I just put in the rear to replace the 4x6's and I ordered two new 6.5" to replace the front ones...

These are the tweeters I purchased: https://www.pioneerelectronics.com/PUSA/Car/Speakers/Speakers-By-Size/TS-A300TW#CrossoverNetwork

60 but the tweeters had line in crossovers. Would that not protect them?

So did I hook anything up incorrectly?

So, the 6.5" are in the Front doors I rewired with 14 gauge wiring. The Rear doors a the 4x6's with 14 gauge wiring as well. The tweeters were tied into the front door speakers with a wired in crossover. All the speaker wires were ran to the Amp. The Amp was wired in with 4 gauge amp kit...

The tweeters had a wired in crossover the 6.5's no

I am new to car audio just decided to try it out and well this is what has happened. Not sure what the difference is between active or passive setups.

So this is my setup AVH-2550NEX Pioneer Receiver 2x TS-D65F Pioneer 6.5" Speakers 2x TS-A300TW Pioneer 3/4" Tweeters 2x TS-A4670F Pioneer 4x6 Speakers 1x GM-D8704 Pioneer Amp Amp was hooked up using 4 gauge wiring all new & a 80 amp fuse on the positive battery wire All speakers were hooked up...