Recent content by MEMPHISKANE

Have you pulled the sub out of the box to see how it is wired. Is it a 2 ohm driver or dual 4. If dual 4 you can wire it up to an 8 ohm load and then use channels 3 and 4 bridged without worrying about throwing the amp into protection/overheating. As long as you set the crossover on the amp...

Side Show had it right in an earlier post. Instead of throwing money at it to get new equipment lets look at the install first. Might not be the best equipment but it certainly sounds like its not hooked up right to begin with. He said he can change the sub out on the headunit and nothing...

First thing check the fuse panel for your Radio and accessory fuses.

Currently running this one Alpine CDA-7998

This was always one of my favorites ran it for a couple years Pioneer Premier DEX-P1R

Never mind the PM, I misread the manual. Thought this unit would work active and wouldn't do me any good

Pm sent