Recent content by mattwsm

Yeah I tried that, didn't make any difference. Thanks for the time mate, appreciate it alot.

No bass remote. Might have to bite the bullet and take it somewhere to have a professional look at it.

Yeah checked it, it's getting 4 volts.

I'll double check it all tomorrow, kinda hoping that's what it is at this stage. Jesus. And thanks for all your help!

The amp only has low pass filter and subsonic for the sub.

I've done all that, I could hardly hear the sub!

From what I'm reading on audisons Web site the speaker load detection only works with high level inputs. See picture. Or am I mistaken? It's all driving me nuts!

I'm running 3 sets of rca. It's a pioneer sph-da230dab.

All 5 channels are running off rca at the moment, the front, rear and sub have there own gain controls, would i not get more power to the sub If i was to run it off the high level input?

Here's a picture from the instructions, what I would like to know is can I run front and rear speakers via rca and have the sub running off the high level input, I've been warned not to do this but looking at the instructions it looks like its OK. It's not very clear though. Any ideas?

I have and its definitely not getting enough power to it, I have to turn the gain to nearly full to get anything decent out of it. It's just not right, would really like to understand how you get the different power set ups on the amp.

Hi, I've just upgraded my sub, it's a hertz mps 250 s2, I need to change the settings on my audison sr 5.600 so that the sub is getting the full 550 watts, at the moment it's wired up using the rca inputs, on the instructions it has 2 configurations for five channels. 75w x4 +330w x1 at 4 ohms...