Recent content by luap

When I was in the process of purchasing the amp I figured I could do just that, hook up each 4 ohm coil to each separate channel but when I started reading the manual, I got sidetracked. Everything they show pertaining to a mono connection requires bridging the amp to a 4ohm load. I got...

Do you think I'll have enough power (85 watts rms ) if i hook up the sub in series => net load 8 ohms? The amp should be able to handle that since the current draw is 1/2 of what it would be at 4 ohms. I'm only running my rears and fronts at 65 watts rms so I'm guessing that it might be...

I just purchased an Image Dynamics 10" dual voice coil sub (4 ohms per coil) and a cheap Poweracoustik 2 channel amp (OV2-300). The amp manual states that the mono connection (+ of left channel to - of right channel) can be hooked up to a 4 ohm load. Therefore, I think I'm screwed since the net...

Does this mean that had one terminal (+) at the amp that was left alone? Thanks, PM

I just purchased an Image Dynamics 10" dual voice coil sub (4 ohms per coil) and a cheap Poweracoustik 2 channel amp (OV2-300). The amp manual states that the mono connection (+ of left channel to - of right channel) can be hooked up to a 4 ohm load. Therefore, I think I'm screwed since the...

I'm looking for one 12" sub with excellent sound quality for under $150, (if possible). Can I get away with using a cheap poweracoustics 2 channel amp, 140 watts rms, bridged.

I'm still in the hunt for some 5-1/4" components. I've narrowed the search down to Kenwood excelon KFC-XR51p or Infinity Kappa 50.5cs. Any opinions? Thanks, PM

Anyone ever hear of MA Audio Y3K5C 5.25in components?

Guys, I've posted questions about components and rears in the past and have received great advise. The one thing that is still troubling me is why do some speakers (same size)require amplifiers with a considerable amount of power than others? For instance, the CDTs require an amp that can put...

Can anyone inform me of the pitfalls of installing a system on a 2001 Buick Regal LS? Are there any above average difficulties? Thanks, luap

Just need to correct my previous post. I guess I showed my ignorance by stating that I didn't think the fronts were as important as the rears. How wrong I was. I played with my factory system this afternoon and came to appreciate how important they actually are. Thanks!!

Thanks for the explanation. My car's front speakers are located at the bottom of the doors but the tweeters are located at chest height along the outside edge of the dash. The car is fairly new so I don't plan on altering their location. Based on this, I was under the impression that the sound...

Thanks for the info. I'm not planning on buying a sub but I do plan on buying a small 4 channel amp, Profile CA440 (65w rms per channel). I figured I need a pretty good set of rears. I didn't think I needed a great set of component speakers. Could you please explain? Thanks!!!! luap

I've just started looking for aftermarket speakers (component fronts and rear) and have come to the conclusion that there are too many to choose from. I'm looking for some rears without a lot of highs (2-way?). Trying to keep total cost below $200. 6.5" component in front 6x9" rear speakers...

Can anyone suggest a half way decent 4 channel amp for less than $100. I don't need a lot of power, just enough to play music slightly loud without distortion. Thanks