Recent content by lowrollin70gmc

Ttt

bump

I'm getting back into construction and modifying my truck's suspension, so I need to haul tools in my trunk along with fabricated truck parts (fuel tanks, ladder bars, etc.), so I would like to remove my system. It takes less room than you'd think, but I need a pass through seat for parts and...

FYI, duece and a half is military term, I will never be from the East. I can't stand other people and being in the Dakota Territory keeps them away from me:). Midwest born and raised on corn and soybeans, (and barley and wheat and durum and flaxseed and canola and sunflowers). To expand my...

From what I see he's putting in 2.5 ton axles, so no IFS anymore for that taco, and a wider stance for the bog. Subscribed

I did the cut off switch while I was planning to put my system together. I have an older truck and I just put my hand under the dash and hit the "old man" switch to cut the bass. It helps on 400 mile trips and the bass can get to be too much. I also shut my amp down while pulling onto my block...

Thanks for the help, I actually kept cruising the net and found the following: http://subwoofertools.com/forum/ported-box.asp It calculated less than 2 cu ft with 2 subs when I played with it. Wish I would have found this before asking. I can get more exact specs with the above link anyways...

Electrical contact cleaner will clean the sensors. My Tacoma had one go out from a K&N intake. But it was too late for me and I had to drop coin on a new MAF sensor. Good luck.

Thanks, that's what I thought but I'ld rather ask then screw up my box.

I was studying the box dimension sticky and had a quick question. I did do multiple searches and could not find the answer, maybe I'm just stupid. Here it goes: I have 2 10" subs that I would like to put in one box. Hypothetically speaking if the manufacturer stated a ported box of 1 cu ft...

A note, if you accidentally slide the tape measure under a metal sheer and cut the end off, it doesn't work so well anymore. Currently I have a wire stripper, masking tape, and a phillips screwdriver. (All the rest are at home, not school). I do have access to tools of envy through college, I'm...

Orange looks good, and that yellow isn't that bad. But make sure you completely jamb the truck and do it right. I hate trucks with door sills, back of panels, etc the wrong color.

4 gauge wiring and fuse holder sold PM & paypal sent.

suicidedoors.com rocks. AIM, Chassis Tech, etc. **** (My system is from there and a SOB to stop leaking. Took 3 weeks to track to no leaks, blew compressor twice.)

WTB: Kenwood 9152D or comparable amp. Looking for 500-700rms @ 2ohms. Willing to pay $150 & up. Must be Class D, not an AB hybrid or 2 channel. Thank you.