Recent content by liqdsm

can someone explain how i do this wiring option? thanks

so whats the best way to wire them if i have the subs in 2 different boxes?

i dont understand why 2 dvc subs are better than 2 svc subs when i can wire the svc subs for 2 ohms and get more power out of amp. while i cant wire the dvc subs to 2 ohm. someone tell me please why dvc subs are better. i currently have 2 ch kenwood 800 watt amp and 2 12" jbl dvc subs in two...

aiight my amp is a kenwood 800 watt 2 ch (KAC-7201). My subs are 12" jbl dual voice coil (GT120D) and i have 2 of them. i want to know if i can run a 2 ohm load on my amp and if so how? also if i cant then what is the best setup? thanks

alright i have a kenwood 800 watt 2ch amp powering 2 JBL 12 dvc woofers. i ve read all the wiring options off this forum and off of jl audio site along with rockfords. none give me a 2 ohm wiring option. so i was wondering if it is not possible for this setup or what. if it is not can someone...

Ok i have 2 4 ohm dvc 12" subs (GT120D) and the kenwood 2 ch 800 watt amp. what is the best way to wire these to subs, to get the most power out of my amp? anyone feedback is appreciated. thanks

Alright i have 2 jbl 12's both handle 250 rms. i have a GMC Sierra ext. cab, but i dont have room underneath my back seat for my subs due to a storage thing underneath it. so i have to have my box on the seat, but im thinking of building two seperate boxes one on each side so people can still...

I tried replacing the fuse in the power wire but it did nothing. so i still dont know the problem and yes my car does still start it just makes a clicking noise in the engine when i turn the key and the amp will not even turn on(power wise). does anyone else have any other suggestions on this...

Alright what i currently have is a stock stereo hooked up to an rca convertor to allow installation of my amp. then that runs to my amp which is place on the wall of the truck that seperates the bed and the cab. i then have my subs sitting on the back seat of the dual cab truck. i had circuit...

Alright well i made the mistake of wiring both my subs the positive of one channel and the negative of the other up to my 2 ch. amp. well the amp usually goes into protect so i just turned down the level and the bass a little and it help up for awhile but then shut off. i thought it just went...

Ok if you look at the bazooka EL series mono amps they have what i think is a amp pre-out to enable a second to be hooked up to it. i dont know if this is what it is for nor if this can be done can someone look into it for me because i know there are people out there that know this stuff. i...

thanks i shall go with that amp then.

aiight i currently have a bazooka 300 watt amp model #el260 but it is definately not putting out what i want. 75x2 @ 4 ohms is not close to enough power for subs(first setup i was just looking for something that hits). anyway i looked at this other mono bazooka amp because i had no troubles with...

then why are they so cheap in price if they put out more then some of the expensive ones?

I looked at the specs on a profile and it says it pushes like 300 watts x 2 @ 4ohms which is like exactly what i want. but is this power overrated or will it actually put that much power out. someone let me know if the profile is even worht it cause i really like the specs and price on the amp.