Recent content by lbjshaq2345

Been babying it for about 2 months now. 10/10 mechanically, 9/10 visually just because nothing can be perfect :P Will be shipped in original crate. Only reason for selling is I want to move to an SPL setup.

Still have the medium?

Bump

I want to learn to do this lol, that's why I'm doing it the hard way.

Bump...

Well I don't really know how to do the math and I don't want to underpower the woofers/tweeters?

Ok wait..****. When the amp sends 125w @ 4ohm to the crossover..then splits to the tweeter and woofer..will the woofer get half power and the tweeter get quarter power (8ohm tweeter)?

Components shipped = $315 Finished install I'd estimate ~$350 to take into account wiring and misc. parts. How do I make sure they're sending proper freqs.? Already have the doors deadened btw.

Nevermind, going with different woofers. Found some I like a little better and they're already 4ohm. Goldwood GW-6PC-4 6-1/2" Heavy Duty Woofer 4 Ohm http://www.parts-express.com/pe/showdetl.cfm?Partnumber=290-307 -Power handling: 110 watts RMS -Impedance: 4 ohms -Frequency range...

The tweeters already have an 8ohm load, I need to lower the load on the woofers from 8 to 4.

Ok just realized the idiocy of that idea. Long day. I'll try this again. Same crossovers, woofers, tweeters, different amp. This time I get how to wire it. Amp -> Crossover -> Woofer & Tweeter. New amp. Pioneer GM-5300T...

Would rather put it all together myself. I don't know where to do this kind of research..links? I don't understand it at all. Don't know where in the line to wire in the crossover or amp. Don't know if the amp runs the tweeters and the woofers or just the woofers. I don't know where to find this...

Ok I think I understand what I need now to piece together the front stage I've been wanting for a few months. Crossovers: Dayton XO2W-2K 2-Way Crossover 2,000 Hz http://www.parts-express.com/pe/showdetl.cfm?partnumber=260-140 -Power Handling: 300W Woofers (2 in front stock location, 2 in...

My cuts were fine, but I originally got the wood cut at lowe's and trimmed it down to the sizes I needed. Those cuts weren't even close.

Might try it then. Thanks guys, that'll be a lot easier than sanding the whole thing down.