Recent content by KRD

Sold to me.

PM sent

I ran my 1/0 under my car. To much of a pain to go through the car for me. Before everyone freaks out, I ran it in pipe. I am an electricain by trade, so one day on the job I bent some pipe . Fits real nice.

I made a set of Front door adapters for my 03 Nissan Sentra, and made an extra set. made of 3/4" MDF to put aftermarket 5 1/4's or 6 1/2's. Should fit other years and models, I am just not sure years and models. If you buy I will cut the speaker hole, you just give me the size it need to be...

Kaotik Racing Development- Was building motors in a race car shop at the time, and everyone called me kaotik. Sorta stuck

I personally like old school amps. Always looking to buy them. Some companys make some great amps now, but there is so much competition now a lot of it is cheaply done or poorly designed. Just my opinion.

ok, it is for a friend that I built the boxes for. 2- 10" Memphis PR dual 4's. Seperate boxes, each sub wired in parallel. Going in a 1970 Olds 98. He dose not have a lot of money, just looking for options for him. Thanks for the suggestions, I will look into them.

I use 1 Memphis M-Class 8" in my s-10, and it sound good. It is in a .35 cube sealed box. Cheap and does not take much power.

I need a 2 channel that will do 200-300 @2ohms per channel. Needs to be as cheap as possible, but still a good amp.

I found that there is no on board fusing, and it comes with a ANL holder. What fuse do they send with it?

Does this amp have onboard fusing. What size and how many? If not what do they recommed. I to have been thinking of getting one, and am trying to plan ahead.

k, thanks. I am not worried about how they clip in just the size. When I get my eclipse I will use the cage that comes with it.

Are all single din cages the same? I have one for a clarion DXZ855MP, but neeed to build a fiberglass consol for my car, but do not have the money to order my eclipse CD5000. I will just need the clarion cage to mold the opening for it, till I get money in a few weeks for the eclipse.

When selecting fuses do you use the rated power of what you are using or the overall rated power of the amp. Example: Rater power at 1 ohm is 2500 RMS and at 2ohm it is 1250 RMS. My setup will be at 2 ohm. Do I use the 2ohm or 1ohm Rating to select a fuse.

I am slowly build my 77 ***** am to do a few meets in SQ. A little about what I am doing. HU- Eclipse CD5000 or Cd7100 Mids/Highs- Memphis MSYNC8's in fiberglass door pods Subs- 4 Sound Splinter RL-i8's in sealed .5 cube boxes Amps- Memphis MCA5004 for mids/highs, and a MCD2500 the subs...