Recent content by kozik

Anyone?

If it were the gains would that cause both amps to go out at the same time though? Because my sub gain is always up but shouldn't that only effect the sub amp not my amp controlling my speakers? If it is a voltage drop what are my options? Big 3?

Stock alternator and wiring with 0 gauge from battery to a distributor in my trunk where it splits to 2 4 gauge wires to each amp no more than 1 foot of 4 gauge... Then the ground is 0 gauge to a distributor that splits to 2 4 gauge wires to each sub. If it were a voltage drop wouldn't I see my...

Hi, I have 2 amps hooked up a hifonics hfi1000.1 and a Jensen power 760. I have 0gauge from battery to the trunk where I have a distributor splitting to 2 4gauge wires 1 for each sub. Sometimes (only happened twice in 2 months) when playing my music loud both amps cut out neither one is in...

The wire to the box is about 2 feet does that change anything?

Bump... Sorry if it's a stupid question.

Hey, I've installed an RE Audio SEX12D4 and it's being powered by a Hifonics hfi1000.1 amp so I'm Pushing anywhere between 600-700 watts to the sub. Now onto my question... The speaker wire I have going from my amp to my box is 16gauge wire but inside the box is just the wire that came with my...

Here is how i have my sub wired (its DVC 4 ohm): This is how it should be: so my way negative and positive go from the same voice coil from the amo over to the other one. But the way i assume its supposed to be is positive goes to one voice coil from the amp and negative goes to the other...

well yea i just wanted that individual front and rear control from the deck. It is more of a nice to have for me that i would like to get but if it's not possible then i'm not going to sweat it. Just wanted to see if there was a simple solution. Thanks for all your input!

i had it hooked up that other way before... 4ch output to the other amp and because the sub wasn't getting a pure sub input the sub was being forced to play some of the treble... like the words and stuff thus distorting the actual sound of the sub. So i guess the way i have it now is the best...

bumpity bump bump

sorry if it's hard to understand. so i have 4 preouts here is a little diagram Uploaded with ImageShack.us

like the title says i have a HU with only 4 pre outs 2 front and 2 rear/sub. Currently i have the fronts connected to the deck and the sub connected to the deck and then using the output of the 4ch amp i have it going into the rears input. I was just wondering if there is a better way of doing...

Well I have mine wired like this 2ohm diagrams shows Subwoofer Wiring Diagrams, One 4 ohm Dual Voice Coil (DVC) Speaker Except I have both negative wires one side and both positive wires on that same side if that makes sense.... So if you look at the diagram in the link it shows the negative...

Yea dual 4ohm