Recent content by kingkongtrunk

maybe i guess i should have said my headunit is a kenwood excelon x493 so amp gain to 4v. i just thought it would need to go higher since my subs can handle what my amp pushes. and ot answer the question my amp isnt bridged. well its bridged internally in paralell. i wired my subs in...

you guys are all assholes. i ****ing said i know you need to use a DMM.

phoenix gold xenon 1200.1 two phoenix gold RSDC 12" subs [600/1200] so my amp is rated @ 1200rms, my subs together are 1200.. wtf? i have my gain all the way up and bass knob turned up a little bit. dont really know whatto do with sub sonic or the other knobs. i have a dmm and would like...

how do you mess with these advanced settings? like the q factor, hz, and things like that? and front hz rear hz sublow hz

and also in addition to that post ^^ how do i properly set my HZ settings on my kenwood excelon x493? I know how to navigate the menus and blah blah, but i dont know what settings i should be cutting off and letting the sub take over

here is the manual ftp://public_user:password@www.rodinaudio.com/Phoenix%20Gold%20Mobile%20Audio/Manuals/Amplifiers/Xenon%20amp%20manual.pdf it says the two terminals are internally wired in paralell not sure if that changes your advice? also i ordered a non fused distribution block from 1/0...

and should i upgrade to a 200amp alternator? I really dont want to spend the 200$ doing that tho.

okay, I have Phoenix Gold Xenon 1200.1 amp. Its 1200 RMS if u dont kno the amp. runs 1200 @ 1,2,3,4 ohms and I ordered 2 of the Phoenix gold RSDC124 12" subs. the specs are 1200w/600rms. looks like it matches the amp perfectly. So am I just going to run the + from one coil and the neg...