Recent content by kickerfan73

  1. kickerfan73

    Rate My Set-up Please...

    If you look close at some manufacture amps sheets they might have somthing that reads wattage measured at 14.4V. Try adding a 2farad capacitor.
  2. kickerfan73

    '06 frontier built project

    I am rebuilding the sub enclosure. I thought of cutting the rear fire wall to the bed and porting to the cab, but I am not sure that is going to be too over the top. not that tack welding in the cut outs later is not possible if I wante to seal it back up, but I think its just too much for my...
  3. kickerfan73

    Which Amp?

    Depending on your budget. I would run a rockford fosgate P400.4 or higher. I would recommend a 4 channel amp over a 2 channel. I am installing soon a p500.4 for the my door speakers. A p400.4 amp will easily run clean at 50WRMS 4ohm on each channel. Then just adjust the gain output at the...
  4. kickerfan73

    How does Bass Boost compare to Bass Level?

    It seemed to me like boost level on the amplifier will make it possible to by-pass the normal settings, and increase the DB level of a specific lowend frequency. For example the amp I have will boost 40hrz up to +18db. At the deck, it has a bass extend setting that basically boost the bass...
  5. kickerfan73

    Who else thinks their system isn't as loud as when they first heard it?

    after only a week the subs might still need another week. Try not turning it up to past 11...(old joke) meaning you really don't HAVE to keep it at max volume everywhere you go....then when you do hear a song you really like, turn it up you get that kick in the seat feel. to add to the...
  6. kickerfan73

    building a box & choosing subs. help the new guy?

    I agree with L-N-L depending on your interest level, try building several box types, large ported, tight sealed, bandpass, etc.. JL stuff is a bit spendy to be messing with so insted of just replacing perhaps its not the box or sub at all. If you havn't already try using a dynomat or...
  7. kickerfan73

    Amplifier Grounding

    Use existing bolt or even drill a hole in a place that won't damage any fuel tanks, hoses, wires, leak water, or create a hole in a fender. I hope I covered all the places...any way the most important thing to do is sand the place you want to contact the ground wire to. If your using a...
  8. kickerfan73

    Recommended 4-channel amp?

    Hello from the south! Congrats on putting a sound system in your ride! I have been building car audio systems for my cars and trucks ever since I was 16. I am not professing to be the best or a professional mobile audiophile. Classify my knowlege to be about at "educated amatuer", so please...
Top