Recent content by justingt

i'm guessing your speakers are like mine- the front speakers do not play bass and distort way bad with the bass and also don't play as loud then. but i'm now going to get some components and amp them to fix the problem

5.25"

Hi, I have been looking to upgrade my front speakers to components for a while now. Right now I have some shitty Pioneer 4x6 coaxiles. I've looked for quite a while for a decent amp and speakers but don't really know what to get. I am willing to spend $200 for an amp and components, and will...

hey thanks, i went out and messed with my ground, and the amp powered up thanks alot

bump

ok, so i got an orion 1200d and i finally got my alpine type r dvc 4 ohm. i hooked it up (i think the right way at 2 ohm) by going from the + and - on the amp to one voice coil and then from the other set of + and - on the amp to the other voice coil. i kind of guessed on the gain and didn't...

ok, so to wire an alpine type r at 2 ohms i would just hook up one + and - to one voice coil and hook up the other + and - to the other voice coil thanks, i figuired thats how it went but i wasn't quite sure

i just got an orion 1200d amp. since it is a mono amplifier why does it have two different sets of + and -?

did u try his new phone number?

I've had my parents call it "that big box and heavy thing in your trunk".

Do sealed enclosures have a tuning frequency?

What does it mean when a sub is "tuned at 45 hz"? I was just curious since I already have a sub and amp but just wondered what it meant.

Just wondering what typically you set the gains at when you use speaker level inputs on an amplifier.

Can someone tell me how to tap a fuse? I am planning on installing a head unit and I have a 01 Grand Am Gt, and I know for sure that I have to tap a fuse or any ignition wire, since the wiring with this car is goofy. I know I have to extend the 12v acc. wire over to the fuse box, but I don't...

I just purchased my first sub and amp and it is still being shipped. I am getting a Alpine M350 200w rms amplifier and 1 Rockford Fosgate P212S4 sub in q-logic box. For now I'm going to use speaker level inputs. My friend has a Kenwood 7251 amp and 2 Kenwood W300S subs...