Recent content by Jules333

hmmm... i guess this isn't the right place to ask questions

ok, so if there no more ideas, how about ways to get around it? I was thinking that i could bridge BOTH 6*9" speakers over channel 1 and 2, when i tried this, the funny sound went away but is this ok? will twice as much power still go to the sub as either one of the smaller speakers? or will...

Bump!

I tried swapping over the sub to channels 3+4 and speakers to 1 + 2 but this time it was channel 1 that was causing the problem. I also checked all the ground points and they all look fine. Any other ideas that i could try out? Thanks heaps for looking... Cheers

No, i haven't tried moving to other channels, it got dark outside before i had a chance. I'm pretty sure the bridge is fitted correctly and there is no mono switch! Thanks for the suggestions, i'll give the swap over a go tomorrow and see what happens tho... i hope i dont have to take the amp...

Hey, I've finished setting up my new system however i've got one problem When i connect my bridged sub (on channel 1 & 2), channel 4 starts to make a weird noise as if theres sand on the speaker cone? I have 2 6"by9" 300watt pioneers attached to channel 3 and 4 and even if i swap them...

bump! (need some quick feedback so i can choose and start building either a sealed or ported box!) Cheers

Haven't been in these forums for long, but finally fouind a topic i know a thing or too about! I'd say for your first bike, do what most people have suggested and definately go a second hand 600(absolute tops), or even a 250 for a few months(depending on how much you have riden before). Firstly...

Gday everyone, Just a quick question... I was reading on another website (http://www.diysubwoofers.org/prt/) that ported boxes should really only be for subwoofers with a Qts below 0.5 (or preferably 0.4). I havent seen this anywhere else and cant find it anywhere else on this forum. I was...

Thanks for that, it looks like a nice easy solution! Probably be best to have one female split to two males tho and have the splitter plugged into the amp wouldn't it? I'm just thinking it be a bit neater and pick up less engine noise... Cheers!

Thats cool! I think for anyone else, having a look at the pictures might really help because i think there is a spot on the amp that maybe i can also attach the rear speaker wire from the head unit to on the amp and them go from the amp(say channel 3 and 4) to the rear speakers... I'm not sure...

Thanks Geowick My problem is that i dont have two sets of preouts on the head unit. There is only 2 plugs, rather than 4. I.e. 1 left, 1 right. The amp has one plug for each of the four channels. I probably didnt make that very clear in my first post! Would i connect the left(from the...

Gday, I've just got myself a new 4*200 watt amp, 12" 800watt sub and 2 300watt 6*9" speakers with the idea that i'd bridge the sub across two channels and run the rear speakers from the other two channels. The problem i have is that the head unit only has two RCA line outputs(one left and one...