Recent content by jetmech727

I've got 5.25 components in a kick panel, the tweater is obviously running off the supplied crossover. I also have 4x6 dash speakers, all running off the channel A of a PG Ryval 4 channel amp that is 2 ohm stable in stereo. I have the amp set to 100hz high pass, however I want to cut out way...

Theres 6x9 in there now, do you know if it will accept a 6" with an adaptor mod?

In addition to the amps breakers? If so, what current rating of fuse would be suggested?

I have two amps, one PG Ryval 4 channel at 75 watts RMS X4, and one RF Mono 300 watt sub amp. I have 4 ga wire from the battery to the distribution block. Is 8ga from the block to each amp sufficient?

I have an Alpine CDM-7861 HU, PG Ryval 4 channel amp, and a Rockford Fosgate Mono Sub amp. What do you guys think is the best way to hook this system up? The Alpine has 2 pre outs, one for the front and one for the rear and speaker level outputs as well. The rear can be assigned to a sub out...

I have an Alpine CDM-7861 HU, PG Ryval 4 channel amp, and a Rockford Fosgate Mono Sub amp. What do you guys think is the best way to hook this system up? The Alpine has 2 pre outs, one for the front and one for the rear and speaker level outputs as well. The rear can be assigned to a sub out...

They will be in kick panels. No room in the doors. Its an 87' ***** Am. There Clif Design 5.25 components, and the tweeter will not be exactly on axis due to were the kick panel is located.

I have an Alpine HU with two pre-outs, one for the front, and one for the rear. I have one mono amp for my subs, and am getting one 4 channel amp as well for the front and rear speakers. The HU has a rear pre-out that can be assigned to a sub out. My question is: What would be my best option...

I've been leaning towards PG right from the beggining. Boy do I miss the 80's, it's really a shame those of you who were to young to remember. What a time that was when the quality of the equipment was incredible, right from the most basic, all the way up.

I've a pair of 5.25" components. Is it best to put the 5.25" and the tweeter together in a kick panel or is it better to just have the 5.25 in the kick panel and the tweeter up in the dash? Right now I just have 4x6 in the dash, so another option is to put the components together in a kick...

Hi there, I've been searching this site for these two amps and have found a little on both of them. PG seems a little more popular. just wondering out of these two amps, which one you would recommend? The MB Discus seems to have more control over the crossover, looks like there sweepable...