Recent content by JdmFinest91

I have full jl components front and rear and a JL 300/4 amp...I would like to know whether it's worth it to rewire the components from the door to the amp or wire it from the head unit area and run it down the middle of the car to the amp..

Bump before bed

yea i think you might of popped your fuse..

Amp Specs * 125 Watts x 2 Channel @ 4 Ohms * 250 Watts x 2 Channel @ 2 Ohms * 375 Watts x 2 Channel @ 1 Ohm * 500 Watts x 1 Channel @ 4 Ohms Bridged * 750 Watts x 1 Channel @ 2 Ohms Bridged Subs are 4 ohm each... i have it wired in series/parallel right now so im guessing im only pushing...

i was wondering if the JL 500/1v2 would be a good amp to power 2-12's type r dvc either 2 or 4 ohm..or should i get a RockFord Fosgate T3002?

yea that seems like my best choice..thanks

i was wondering how would i go about wiring my 1-10" dvc 1042D alpine type X...would it be best to run 500 watts rms amp to each coil? or to wire the sub into a 2 ohm load and run it to a 1000 watts rms mono amp? i'm pretty new to this..so let me know what u guys think or any suggestion would be...

as the title says let me know how much and shipped to modesto ca...and the condition of it

bump1

so they best way to wire up my speaker is in Series? i have them up as parallel right now..

Bump very powerfull AMp

Bump!

As the title says 300$ obo it's in excellent working condition... need it gone today...if interested leave your contacts thx..

hopefully haha ^_^

350$ obo it's in excellent working condition what you see is what you get...it's just a bit dirty that's it..