Recent content by jbotelho15

It made it better having gains low but now my music isn't loud enough and it's still there just less noticeable when I unplug the rca cables it's gone so the problem is preamp and the rca itself is good because I plugged both ends in and still no static. head unit is factory and untouched so it...

I read on another site that if gains are set too high they can cause a constant noise at zero which is what I have. My processor has gains as well as my amp. Processor gains I have at 50%ish and amp gains 75%ish but for the subs processor gains are at 80%ish as well as amp. Could I lower the...

it is an AudioControl LCC6i Processor and I have nothing connected to the factory head unit it has bluetooth and a hard drive that I play my music off of so no wired connections there. Today I cleaned up my wiring in the trunk so its not messy and rerouted it so no power anything except for...

It is a factory head unit that's why I have the processor and the processor power does cross the RCA's at a 90 degree angle. I will seperate them entirely to make sure.

So when the volume is at zero you can hear static. I have a 18 Gauge Remote Wire from fuse box under dash to processor in trunk then 16 gauge remote wire from processor to amp I have a 5 channel amp that goes to all my speakers and then powers my subs (Power & Ground 6 Gauge both to...

I drive a 2012 KIA Optima Hybrid, Here is what I have to work with, x4 JVC CS-HX649 (4 ohm 50w RMS each) x2 Infinity Reference 860W (4 ohm 250w rms each, will wire to 2 ohms) AudioControl LC6i Factory Sound Processor Now Im stuck between two different amps (feel free to reccomend something...