Recent content by jayxpk

real men drive standards anyways

i have a bench seat in my single cab pickup with 2 10" JL's in sealed boxes behind the seat, only had to move the seat one notch. pounds harder then any other system any of my buddys got in there cars and its no wear near as good. bass gets twice as loud with windows+ back window open, and...

go to sleep by eminem and bump heads by 50cent/eminem/gunit and hip hop by dead prez have the most bass in an actual song that i have heard if u go on kazaa lite and dl "deep *** bass song" its got a TON of bass any bone thugs/wutang/three six mafia

kk thanks man.

can someone please help me? i wanna know so i can do it this weekend :S

i found a diagram that i just want some reasurance on http://www.bcae1.com/images/gifs/bridg24.gif im gonna be doing the bottom diagram..will that work fine?

i have 2 jl 10w0 at 4 ohms each, my amp is a rockford fosgate that puts out 50 rms per channel.it is 2 channel. also, it tells me how to bridge the amp right on it, either left+ to right - or vise versa i forget.

i have 2 subs and one(1) 2 channel amp, is it possible to bridge the amp for the 2 subs? the amp says that it is bridgeable, but from what i understand is that you can only bridge 2 channels for 1 sub? is this correct? any help would be appreciated thank you.

thanks for the help man. i ended up makin 2 seperate boxes anyways but now i know in the future

i cold wired my 91 jeep comanche and what i did was i took the 2 door wires, twisted them together, then used a meter on that beeping mode and found the 2 wires that made it beep, thus they are the door speakers. thats the easiest way i could think of doin it and it worked just fine.

thanks a ton for the help man, building my sub boxes right now, almost done will have it all hooked up tomorow and ready to adjust the gain

hate to ruin that guys thunder but u can get more then that for cheaper on ebay or just do what i did and buy a dreamcast +2 controlers + 2 vmus + 5 games, then buy 200 blanks and burn away

im very curiose about this too as i was about to post a question about it.. adding on here. is there an advantage to have high or low gain? and how do u figure out what its doin..like on my amp ill vbe turning a screw..but how will i know what its doin and if i got it set right?

kk thanks for the help man always wondered what sq and spl were lol.

well yes this is my first time building a box, however my dad is extremely good at woodworking and hes gonna help me with it..so i dont think its gonna matter about hardness. i guess i might as well ask now..what is SQ and what is SPL? i just want a deep bass that sounds nice. its goin to be...