Recent content by jason_r83

should I do the wiring option #2 as seen in this link? I just find it wierd to be cross a negative with a positive, but then again I've never had to deal with a sub that had more than two inputs... thanks the amp manual says that it's stable from 4-8 ohms when bridged...

so that will work if I just wire one channel to each side? Someone told me about doing it the way I did it but instead of running the wires from one side of the sub to the other with the same polarity; to criss cross them, positive to negative and vise versa...

I dont have anything hooked up yet, so I dont have a way to tell

it has two of these on it- this one and one on the other side

I have a pioneer 760 watt amp and one DUB 800 watt sub. The sub is dual 4 ohm. I bridged the amp. Here is a little sketch I did. Did I wire it right? thanks I've never had a sub that had four inputs on each side. I've just had subs that had two inputs and that was it...lol p.s. I wont know if...

My amp has a speaker input on it as well as the rca input. I'm going to be using the factory head unit for awhile, so I'm going to splice into the rear speaker wire and run them to the amp for my sub. Will this cause my rear speakers to sound worse because half of the signal is going to the amp...