Recent content by ib2loud

For 3/4" JL Audio tweeters. The metal spring clip thing broke on me and I am unable to find a part number or a place to order replacements. I'm sure any similar installation hardware would work but I'm not real sure where to look. Any advice is appreciated!

Necro bump but do you still have these? They look like they'd be perfect to match the interior of something I'm working on.

no it shuts off every single time no matter if i just started it, i'm idling, or I'm driving down the highway. it shuts off at a really low volume. it still is shutting off with the engine off now too but it will let me turn it up a bit louder it sounds really good whenever it does work so I...

I was thinking about adding the alt wire. I also am planning on getting a kinetic battery to see if that helps, plus it's a lot smaller in there too. The thing worked great a few minutes ago with the engine off and as soon as i started the car it started cutting off again

I am running 8 gauge cables to each amp, with about a 6 foot run to the battery. The impedance is 4 ohms mono which the amp should be able to handle fine. I think something is wrong with the car because when i was driving down the highway at 75mph the headlights would dim really bad when the...

It's just a homemade jobby but here's mine:

Car is a 2007 Dodge Charger. I am running all Kicker equipment, a 450.2 on a CVR12 and a 200.2 on some 6.2 components and some 2 way 6x9s. The mids and highs work fine but the sub amp cuts out any time I barely turn the bass up. The voltage stays pretty constant around 12.5 with the engine off...

This is my daily driver.

because i like Kicker...same reason you like your brands. Everyone is entitled to their own opinion. i went with the CVR

Thanks what if I throw a L510 into the mix? still say the CVR12 will be the best sounding setup? I don't want anything loud but i do want it to be able to produce the lower frequencies the C12 I have now may be fine once i get it into a bigger box

posted in your other thread but i figured i'd go here too. do you still have the Kicker 6.2 component set?

old thread i know, but do you still have the 6.2 component set?

i saw that and already posted a message i have a C12 right now but it's in a pre-fab box and sounds pretty weak. i just got it a couple of weeks ago to have something setup for a car show I was entering and now I want to do something a little more permanent. sorry about the title, i meant...

what do you think the enclosure should be? I was just going off of the CVX10 manual stating 1.75 with a 2.5x10x20 vent. I'm not too sure what an aeroport is, any info? I appreciate the help

yeah...i don't do the loud stereos like I used to but i've had the screen name for 12 years so I still use it you don't think the 450.2 would be good for the CVX10 in the vented enclosure?