Recent content by GRell07

I'm no good at soldering

Model: TSW3002D2 RMS: 1000W Peak: 3500W Looking for a amp to power this sub, have a HiFonics 1000d right now and it comes on basically when it wants to (works one day, next day some of the day). Thought that amp would have sufficient power but I need some suggestions for a new one.

Yea I seen it on there wasn't sure if it would light up or not. I have never seen it lit so im thinking it may just be a loose cable somewhere.

Will definently look at that remote wire. JUST replaced the battery so it could be but some amps have lights that inform about protect mode right? and some have a protect mode but aren't always lit?

That was my thought but then I thought why wouldnt it go into protect mode? or is it without letting me know? I think imma just replace the amp. I wanted to when that first happened but since it came on and seemed to work fine, i just let it go.

yea i did check. cables seemed fine. I'm thinking its the amp as well because even when the sub goes out it comes back on as soon as the amp lights up again. Also I DID have one day where a spark and a little smoke came from it but I think one of the wires touched my stabilizer bar in the trunk

not to the touch, no. I usually take it to the shop and they set the settings so I wouldn't think but its possible.

Hey Guys, new to the forum and this is my first post! I DID read the stickies but i'm pretty much an audio novice when it comes to ready that. I have a problem. I recently bought a new subwoofer (Pioneer Premier TS-W3002D2; 1000 RMS, 3500 peak). I kept my same amp i had which is a HiFonics...