Recent content by green draggin

Any repair history ?

I had a similar issue with my mechman 270 and it had to go back for a tweak. My big block idles at 700 in park which was fine but 650 in gear didn't provide enough rotor speed to turn the rectifier on. I wouldn't change the alt pulley to a smaller one cause chances are it already has a...

I don't know much about the newer diamond stuff but I have several old school d series amps. They were designed and manufactured in USA by esoteric audio before diamond took them over. Top notch build quality, beautiful board layout, and great crossover networks. Even have variable rate active...

Where's everybody at ?

Ehh.....No rush.....my truck is still all ripped apart. Nothing like a last minute thrash!

I'll be there ! Will be arriving Friday evening hopefully

I would say 5-4-2018 is pretty recent wrongdoing

I'm not competing. Just going to check out all the rides and have a good time.

Who all is going and where is everybody staying at ?

I run a pair of plutonium 4k's. Have no complaints with them. They're wired at 1.2 ohm each because of vc configuration, but they really come to life wired at .6

Gotcha ! Was just curious about the vp, it's one on my list if I can unload my 2 ground zero 4k's. I'm kinda in the same boat, 4 d1.2 coil subs that leaves me being able to wire each amp at 1.2 and rise from there which is no good. My only other option is wire each at .3 which I'm not...

Where are you wired at on that vital power ?

Have a ground zero plutonium 4k for 500 shipped

I'm just old, and ran alot of us amps back in the day. Actually it wasnt all that long ago i was still running a vlx 400 come to think of it.

100x2 @4 ohm 200x2 @2 ohm 300x2 @1 ohm 600x1 @2 ohm bridged All are 12 volt ratings, a bit more at 14