Recent content by Gnfanatic

This is my collection so far. PPI A600.2 PPI A404 Soundstream MC245 Soundstream MC140

Bird catcher?

I agree, thats not a stock wing. So take off that wing, ground effects and that rediculous scoop on the top. put fac wing back on and leave the body alone. Nothing like seeing a untouched supra (I like the white ones).

that Supra was ruined. that alll that body crap off of it.

Thanks for the support I have a pic to to prove it sint ghetto

Are you an ******* or something? It Isnt ghetto style, I have been soldering for years, its tested out great and is now solid. Keep your ****ing stupid comments to yourself.

Phantom, I did take it apart. part of the board was cracked which stopped the + going to the coil! I removed the protective layer down to bare copper, soldered and epoxy'd it. works perfect! thanks! Ralph

hmmm, I thought I was. One of my crossovers from my component set is bad. I tested the speakers, they are good. I swapped wires, crossover still does not work.

Hey guys, jsut finished installing my system. Bought a new set of DLS up6 comp from a member 2 months ago. now everything is hooked up and my driver side tweeter sounds very low and horrible and the mid off. The other side sounds great. I put the bad tweet and mid wires on the good crossover...

I mam trying to make as diff as possible to steal. I also bought alot of security type screws, etc. any tips would help! thanks Ralph

Thanks guys!

good, they arent the cheap crap, I think they are Acoustic?? they are grey in color.

Hey guys, due to the tight tolerances on the moldings, I need to run my 2 rca cables (higher quality) with my speaker cable for the pass side comp's and the remote wire. The power wire is going on driver side. So will the rca's be ok with the speaker cable??? I am a little worried about...

Hey guys, need your opionons here. Going to be installing my amp rack. I want it to be evry difficult to remove. I was thinking drilling 4 1/2in holes and using 1/2 inch bolts?? Is this over kill??? thanks Ralph

So I went to pick up a HU today at a local place. While I was waiting I went over to the monster cable section. 2 gold plated #4 GA terminals $9.00. WTF? How much does it cost to make 2 terminals in China? 20 cents? 0 GA cable, $6 a ft, YOu can keep it. I dont know if it was the store or thats...