Recent content by gilbert383

ok if i went with the BXI-2010d and the 2 12w6v2 and 0 gauge wire a 2 farad cap i should be good...unless when its installed my lights are dimming crazy then go with a couple runs of the 0 gauge with a distribution block and big 3? is that hifonics amp rated at .5ohm?

i feel like such a n00b when someone says stuff like that big 3 kit? a few runs of 0 Gauge? ha i only know to send the power to the amp and ground do a ground how r u gonna get a few runs...dont laugh lol

can u give me a link to the rd...and i'm not trying to put a new alternator or battery in the back i can deal with a little dimming could put a cap in there but not trying to spend outragious amount of money on this...i wouldn't see why a 1500 watt rms would hurt it too bad i've had 1800 in...

okay so how about a hifonics bxi-2008d or a sundown 2000d

so for these subs if i got the sundown 2000d i'd have to turn it wayyy down wouldn't i?....

okay...what is THE MOST you would push these two subs at rms? and no im not stuck on either of them i'm just saying that those 2 are ones that will push 1000 rms no matter what ohm u put them at and both seem to underrate their equipment if you guys have a better suggestion for an amp on these...

I just picked up two 12w6v2 subs recently and i've narrowed down my amp options to these two. Feel free to suggest a different amp but i'm not looking to spend more than $600. I have heard that these amps are about as big of rms as you can have on these subs and may even have to turn the amp...

u get it?

when u get that can u post ur opinion of it....i'm planning on buying the amp i just want to know how hard it actually hits.....what kind of vehicle are you putting it in and what kind of subs are you using

what about the profile amp...does anyone have it....or is it any good...i was also thinking about buying it

i'd also like to know about the rms rating specifications....is it ok to go a little over and if so how far....whats wrong with the profile ap1000m amp exactly?

Well i'm new to this site and i've got a couple questions.....i have 2 12" Jensen subs in a bandpass box and the RMS is 400 and the Peak is 1200.....was wondering what kind of amp i should get that's less than $150....saw the profile ap1000m amp is that any good?.....thank you for your help