Recent content by gerardc

thanks i am thinking of these x3 TS-W5102SPL Premier® 12" Component Subwoofer with 6000 Watts Power 2500 Watts Maximum Power Pure Titanium Voice Coil Interlaced Carbon Fiber Reinforced IMPP Cone Suggested Price: $1,000.00 the main problem is i want to enclose about 3/4 of the trunk in a...

thanks

anyone know of any good programs to download for creating boxes? 3D designs?

What would you guys say is the best and easiest way to figure out box cals based on the subs you use? I.E. Watts MAX. Music Power 6000 Watts Watts Nominal Power Handling 2500 Watts Frequency Response 18Hz ~ 2kHz Sensitivity 88dB Ohm Rating DVC (1ohm or 4ohm) Recommended Enclosure 1.5 Cubic...

thanks

I just made two sealed boxes for pioneer 8in swollow mount subs. it said i only need 2.5 ins of mounting depth. so i made them so they would fit the truck. 13L x 9W x 4D outside to outside specs Will this work or is this to much air space. So do you also think if i put a 2in port in it by...

Hey all I am trying to find a good school to go to, to get my cert. does anyone have any good listings I could take a look at? I live here in New Mexico now and was looking for a close school in the near by states. I want to learn everything I already know some fab, wiring, and compont stuff...

so will this work

I was going to make the sub box 6T X 16L X 11W will that work? I am asking because the sub from top to bottom is 5 1/4 ins tall. so from the bottom of the magnet to the bottom of the box will only be 3/4 of an in. will that work as long as the box is wide for the air space?

so do you think the box will work even if i sink the sub flush with the top?

If the manual says 4 15/6 mounting depth. Is that from Bottom of box to bottom of sub or is it bottom of box to top of sub? I am asking because the sub from top to bottom is 5 1/4 ins tall. Also It is a 10 kicker sub to go under backseat of F150 I have. Minumum enclosure volume is 1.0ft3 Max is...

If you look at a new 05' dodge dakota you can see that the center console plastic and i am making one out of 1/2 mdf but i can't get how to make it curve as well. I am just trying to make the same console just out of mdf. Copy the URL and look at the center console. It has a cup holder at the...

i am making a 3 sided box so i can faber the top. the bottom is fat at one end and then becomes smaller as it goes back. how do i put sides on it? the side would have to curve as well. how do you make a board curve? Not good at making 2D into 3D:)

Do all subs have 3/4 in rims for boxes? I.E. 10in sub 9.25 box rim I.E. 8in sub 7.25 in rim

i will have one of them here soon. I am trying to keep the design about the same but add ipod slot and the subs. i have 10.5 ins to work with at the back. where the subs will be.