Recent content by gbleezy

I currently have a 12" L7 ported running off a PDX 1.1000 in my Tahoe. I'm thinking of switching to 2 10's ported keeping the same amp. Would there be a difference in sound? I listen mainly to hip hop but I like tight sounding bass and not so much boomy bass. Would 2 10's give me the sound I'm...

so my PAC line out converter has 4 channels and when i turn the adjustable knob for LR and RR i notice the bass turns up on my sub (and also increases the voltage my amp sees when the dmm is hooked up.) when i had my amp installed the shop set the settings for those channels about half way but...

so when i google "non-inductive dummy loads" or "dummy load resistors" i see them in 4 and 8 ohms, do they have them in 2 ohms and where can i buy them from?

it ***** cuz my stock HU doesn't show specific volume levels, i either turn the knob clockwise or counter clockwise so i have to guess where 3/4 of full volume is.

just wanted to make sure, thanks ya'll!

yeah, i currently don't have access to a clamp so you're saying i should set the AC volts to 40?

cool, thanks for all the help.

I don't have my sub hooked up when setting the gain. I'm not sure why it's beeping. I played the 50hz test tone, set my dmm to 200 in the OHMs section and numbers just kept changing rapidly on my dmm and it was making beeping sounds, kinda like when you roll your r's with your tongue. Also...

I don't think so, I connected it to my battery and it seems right. the only settings on my LOC are for LF RF RR LF and those are little dials you can turn, the shop that installed it set these. according to kicker the sub is wired to 2ohms. there's 4 settings on my dmm for ohms, 20M, 200K, 2K...

Newbie needing help here. So I have an Alpine PDX 1.1000 hooked up to a stock head unit using a line out converter. It's pushing a 12" Kicker L7 in the ported box from kicker (11VS12L72). I have the gain all the way down, I turned the treble, mid and bass all the way down on my HU, played a...