Recent content by gabossboy

I know the specs so that will not be need. I have a PA 2400d Amp. Its supposed to push 1800wrms at 1 0hm. I'm Curently runnig it two two kicker l5 dual 4 ohms. i would like two add 1 more. Question? can this amp handle at .67 Load, for 10-30 minutes constantly.

I checked all of my connections. I get between 12-13 volts from the power cable. The problem is once I plug the power and the ground wire into the amp it sparks, and eventually a fuse blows. My ground wire is about 2 ft long and never touches the power wire. The fuse that blow is not the inline...

I personally installed my system. It worked fine until the other day when I disconnected my amp. I was trying to install a new amp, but once I connected the the power wire(last thing I did) I got a huge spark and blew my fuses on my amplifier(not the ones on the power wire). So then I tired to...

I personally installed my system. It worked fine until the other day when I disconnected my amp. I was trying to install a new amp, but once I connected the the power wire(last thing I did) I got a huge spark and blew my fuses on my amplifier(not the ones on the power wire). So then I tired to...

don't know exactly what its called, but their is one on each negative a positve terminal. 4 in all. One always breaks from one of the terminals.

i think its the tinel lead, and the enclouser is pretty small for the sub.

I have a kicker 15 L7 1000wrms hooked up to a Hifonics Brutus 1200wrms. But for some reason every few weeks I have to repair my Sub. I am starting to believe that Its because of the bass boost but im not sure. Does anyone know what the problem might be.

Checked the groud, ran a new remote wire, still getting same problem. Also checked my power wire and found out that it runs at 12 volts before being connected to the amp, but once its connected it measures at 2 volts. No speaker wires are connected, or any rca cables. Only wires connected are...

My amp powers on but after about two seconds it turns off. The power wire to the ground wire measures at about 12 volts and the remote wire to the groung wire measures at about 7 volts.

I need help on how to remove the stock radio in a 2003 chevy impala. I also need to know the bet place to run the power wire from the amp through the firewall of the car.

First Off I would like to let you know that I know very little about car audio installation, but I did take an Electronics course so I know how to bridge connections and wire things to higher or lower impedance levels. I Have a 2003 Chevy Impala, that came with built in Premium Sound. I Will...