Recent content by fst89lx

yea, rear end gear changes aren't really all that hard, my father and I swapped gears and rebulit the trac-lok in my mustang in an evening. Just take your time and make sure to check the backlash! If it whines when you get it all put back together, STOP DRIVING it! and go back in and make sure...

Ok, according to winisd a port that is 12.5x4.5 needs to be 18 inches long to tune a 5cu.ft box to 35hz w/ 2 dd9012's. I am going to be using a slot port and the box walls will be part of the port (3 of the box walls will also be walls of the port) Now, JL's site says take 1/2 of the ports...

Ohhh, ok then Thanks!

I know it sounds dumb, but I need to know real soon so I can buy some distribution blocks. Thanks!

Ok, I see that the general consensus is that a fused dist block is NOT needed, so I guess I will not use one. It'll save me a little cash in the process too

That is what I am going to do (which is why I need 2 blocks that are (1)1/0 and (2)4ga) Also the power wire would of course have a fuse at the battery, but I just figured that it would add extra safety to fuse each amp separately at the dist block also.

one is for ground and one is for power for 2 amps, so a single 1/0 in and 4 4ga out wont work. I guess I don't really need a fused block for power, but I thought it would add some safety in fusing each amp at the dist block. (btw its 2 dei 1100d amps) I will try sounddomain and knukonceptz...

I looked at parts express and they didn't have what I need. I need 2 dist blocks, one fused the other not, both must be 1/0 in and 2 4ga out. where should I look to find these pieces and approx. how much $$ will they run me each? Thanks!