Recent content by fonyx

Kicker KX700.5 (5 channel amp, 700wrms, 900w max) power a kicker cvr12 dual 4ohm sub in 2ohm mode at 400w, and 75w each channel for infinity 3ways i have a 90a alternator in my car, and the amp is running on TWO 10 gauge kits wired together, the wires were already in my car from two previous...

I only play dance music in my car, which is basically in the 140 bpm range, so the bass is quick, accurate and tight Right now I have a kicker dual 4ohm, cvr 12" sub in a 1.75 cubic foot ported box, but the bass is a little too deep and hip hop like , shakes my trunk, gives off a low rumble and...

Alright, I have a Kicker KX700.5 five channel amp, with a kicker cvr 12" dual 4ohm sub, 1.75 cubic foot ported box, infinity 3 ways, boston 2 ways the gain for the sub channel is set to full, bass boost to 15 out of 18, frequency is at 100 out of 200 gain for the speaker channels is at 3/4 of...

I just installed everything, and it pounds like crazy!! I only have the volume on my Pioneer deck set to 14 out of a possible 30 max volume level, and it makes my ear drums hurt.

I don't know how it sounds because I still need to buy 4 gauge wires and a warm garage to get crackin

I returned the woofer and picked up a Kicker dual 4-ohm instead.

Anyone running this amp ? Curious to hear some feedback

Have I made a wise purchase?

I went to a local audio shop today, during their 30% off everything anniversary sale and picked up this sub and box to go along with it... i will run it on the kx700.5 : Kicker CompVR 05CVR122 12" subwoofer with dual 2-ohm voice coils » 12" sub with dual 2-ohm voice coils » suitable for...

any particular model ? also, I'm told that running a sub at 4ohms is better, because there will be no distortion, and nice deep pounding bass... true ?

Kx700.5 , 5 channel amp 200 watts x 1 RMS at 4 ohms on the sub channel or 400 watts at 2ohms on the sub channel http://www.hookedontronics.com/show_product_details.jsp?cid=4774#fe I will be mainly using the amp, speakers and sub for dance music... etc thanks !

Ok, I'm using an Alpine MRP-T130 amp ( 2 x 50w ) to power Boston Acoustics 2way sl65 speakers the connections are all solid, but depending on which channel input i use, one speaker sounds a lot quieter than the other, almost as if it has no bass, just mids and highs... but if i switch the...

Thanks for all the replies, I'm new to car audio and trying to gain as much knowledge as possible. cheers

Ok, lets say I do run this setup for example, with 8 gauge wires, would I need a capacitor ?

well, can I feed the speakers the full 139 watt RMS and not worry about them getting destroyed ?