Recent content by foley420

you mean as in two different boxes? becuz i have my subs in one dual box? but im guessing its alrite so i'll be havin them both hooked up later today.

bump. any thoughts?

I have a kicker 750 watt at 2 ohms mono channel amp and 2 kicker 12" l5 subs. well recently i was having trouble with my amp and figured it was the ground. i fixed that but in the process of fixing it, i tried many different things. one thing i did was disconnect one of my subs so right now only...

lol too **** far of a drive for me. especially for a problem this simple. haha i measured all the voltage like u said. the amp, the battery, the power cable, and finally then ground. haha who coulda guessed it was the ground....lol thanks for all the help though guys!

ha nevermind, problem still exists. but i seriously believe it is the amp. I disconnected one of my subs so only one is wired. with this setup this has been the longest it has been working fine. until now....i tried to disconnect the power cable from the battery and reconnect it again. this time...

follow up: found the problem. apparently i set my frequency to high and that overloaded the amp. i disconnected the power cable from the battery to reset it and connected it back and the problem was fixed. thanks for the help!

my gains were set at the lowest and i adjusted them alittle higher, and then i messed with the bass boost followed by the crossover frequency. the subs and amp were working fine and then when I changed the song there wasnt any output. but now that i think about it, it might be the ground...

any help?

earlier today i installed 2 kicked l5 12" and a kicker 750 watt 1 channel amp. I was tuning the amp and at first it worked fine with a green led light on the amp like it was suppose to have. but then i changed the song and all of a sudden the amp went to red flashing light. i read the owners...

they're DVC's and 2 ohm subs

hey thanks for the help and the welcome but i have 2 kicker 12' L5's at 2 ohms and a mono kicker zx750 i think? yah its 375 watts at 4 ohms but at 2 ohms its 750 so i hope thats good? im pretty new at all this but i think i've gotten the basics so far atleast haha.

i was wondering if it's possible to power 2 subwoofers with one mono channel amplifier?