Recent content by Flatbush Boi

  1. Flatbush Boi

    Will this blow my mids??

    im considering buying a 1200 watt 4 channel amp its rms at 4 ohms is 110 x 4. the problem is that two of the mid speakers that i already have are 4 ohm with 70watts max and 35rms. so im guessing that with this amount of power (110) going to the speakers (70/35) would damage them. is there...
  2. Flatbush Boi

    Quick question.

    perfect man thanks for the help.
  3. Flatbush Boi

    Placement of Sub and port for best response.

    when i had a ported enclosure it was louder when facing rear. when i had it facing forward it was a little quieter, but it bumped on the backseat more
  4. Flatbush Boi

    Quick question.

    given the diagram on the link does it have to be wired like that? im asking because i have two subs, two speakers, and a 2 channel amp. i was just hoping to splice one speaker with one sub and the other speaker spliced with the other sub (simplicity).
  5. Flatbush Boi

    Quick question.

    would it be ok to splice a speaker with a sub going into an amp? im just wondring because im worried that itll push too much low frequency to the speaker...
  6. Flatbush Boi

    Pro Series Brand??

    Lol i cant tell if your being serious
  7. Flatbush Boi

    Pro Series Brand??

    ill have picture up later today.
  8. Flatbush Boi

    Pro Series Brand??

    i was recently cleaning out my uncles garage and found a 10in "pro series" sub. Im guessing pro series is the brand since it says it right across the front. i cant find it anywhere online and the sub itself isnt giving me any clues in terms of wattage, just that its 4 ohms. So basically im...
  9. Flatbush Boi

    Is my amp enough? Or different wiring necessary?

    Could you briefly explain why this amp in particular isnt good to bridge. And a monoblock amp running the subs parallel...? Is that best option or any other recommendations?
  10. Flatbush Boi

    Is my amp enough? Or different wiring necessary?

    well while i was waiting for a reply i just went out and bridged the amp (amp to 1st sub, 1st sub to second) and flicked this switch from stereo to mono on the amp. they hit harder now and it seemed to work finw but from what you said, should i undo this due to risk of blowing my amp?
  11. Flatbush Boi

    Is my amp enough? Or different wiring necessary?

    ok so i currently have two of my 4ohm 10s(500watts ea.) hooked up to my 2 channel 1100 watt amplifier. The amp claims it pushes - 2 x 125w at 4ohms, 2 x 250w at 2ohms, 1 x 500w at 4ohms Maxx. Now dont get me wrong because this setup DOES hits fairly hard, however my question is if each sub is...
Top