Recent content by ferret7cs

ya it does... we called the company now, and they said we better send it in, so it sounds like they will replace it, if its under warrenty ok...

My freind got a 1800 tsunami and a 15" XXX dual 4 ohm. He hooked up the XXX and the amp is ALWAYS in protection. He used to have a 10" Type-R hooked up and it worked fine. 2 Problems made that, i dont think matter, was the RCA's were plugged into the Output for a small period of time, after the...

My freind got a 1800 tsunami and a 15" XXX dual 4 ohm. He hooked up the XXX and the amp is ALWAYS in protection. He used to have a 10" Type-R hooked up and it worked fine. 2 Problems made that, i dont think matter, was the RCA's were plugged into the Output for a small period of time, after...

I am helping my freind build a box for a 15" XXX sub, running 1800W RMS at 2ohms, i was wondering how dense of wood do we need for that much power? We were thinkin medium density fiber board, but not sure. Also, would lining the inside of the box with e-dead v.2 do anything good for it?

I am using the program WinISD alpha, and i have the option of adding mass to cone, how do you do that? Ive knotcied it gives you for SPL at lower tones, but lose just a couple db at higher notes. Does it mess with the SQ at all... and how do you do it?

http://www.diysubwoofers.org/portcal.htm is the formula you need, just plug everything in and figure out your port size.

I am doing the calculations to figure out teh right port size, but the port diameter, im assuming, is meant for a circle. What would be the port diameter of a rectangular port?

Tuning a box is making the correct size port according to your hz. http://www.diysubwoofers.org/portcal.htm is the formula you need, just plug everything in and figure out your port size.

Thank you, like i said he talked to the RE man, and he is building it from scratch for him, so forget about the whole ohm situation...

I'm rez's freind and talking to him now, he cant get on the computer and i helped him build this system, he talked to the RE when he ordered it and he set it up right to run it at 2 ohms, which would be 1800W from the tsunami, His car also puts out a solid 14 volts continous, and he baught a...

I have 1 1221D Type-r. I have a 2 channel amp, and ive heard stuff, dont know if i read it right or what, abuot taking 1 channel to each VC to the sub. Did i get that right or should i say can that be done? Cause the standard wiring diagrams i have seen are a Dual 2ohm can be wired at either...

My freind is looking to get a up to 5000W RMS to run a 18" solo X. And he wants to know what would be a good amp for around 900 which might be hard. the 5000 is highly unlikley but he needs a lot of WRMS, hes looking into the Visonik V4000XD whichgives 4000WRMS for only 680 and free shipping...

What is the XXX, heard much but im not in tune with this "Lingo" yet

I'm thinkin about gettin a new 15" sub. I got about 700 bucks to spend on a amp, box and sub. I was lookin into either an Eclipse Titanium series or a ED 15" A. Which would you think would be better? or would you recommend anything else?

yes how i would really love to know...