Recent content by Fender91

so say i have 4 accessories, the power and ground wires of each goes into a switch box thing and the same amount of wires come out, from there they all go into a dist. block, then it goes to one power. ?

whats with all the hostility??? anyways if u do end up installing a manual ****** down the road ur not gonna have any room for a clutch pedal with that kick panel there

the harness wont plug in most likely and the computer wouldnt recognize it

Ok so ive got a bunch of accessories in my truck that are currently not laid out too well. I plan on organizing it all by using a distribution block so i dont have a ton of wires on my battery but how would i be able to run switches for the individual accessories with a distribution block?. i...

the box is 1.32 cubic feet per sub so 2.64 about i might be off .01

heres the sub

do all ported boxes produce a port noise?

the 2 subs ar like divided by the port so its vertical and its in hte center, but like i said i only notice this noise when the seats are down

nope or atleast not that im aware of, i noticed my mojo made this noise when it hit really low notes, perhaps its the box resonating at a certain note? but its weird how its really noticeable with the seats down versus up, but it sounds like its coming directly from the sub

I just installed 2 type r 12" subs behind my rear seats in my avalanche but when i lay the seats down and u can see the sub, you can like hear the sub moving, of course i dont mean the bass it produces but like u can hear a fluttering i guess you could say? is this normal while a sub is still new?

wait so then how do i do this?

they are 2 ohm subs

and that still works out to 2 ohms? thx

excuse the bad drawing im using a laptop, but is this drawing correct looking

yes but the wires are being run thru the box as if theres no wall is what i mean, is there a way to re wire it using 2 terminals to not have to drill a hole in the box to connect the 2?