Recent content by Ezzy4Vibes

I reset my gains using an oscilloscope making sure there is no clipping. Then switched RCAs and speaker connections to opposite and the noise is still there. Then disconnected RCAs, speaker wires and tested the amp with my oscilloscope. I found a constant 2-4k hz noise signal on the speaker...

Quick run down on install 2019 Mustang GT base 4.2" sync radio/ non-amplified Stock Installed: Pioneer C2550NEX headunit Maestro RR (steering controls) Hertz K165 speakers component front...

Amps are grounded separately. I set gain at 3/4 tilt before clipping, at 0 gain the noise is there. As another said, I will check amp to tweeter wiring for issues.

Quick run down on install 2019 Mustang GT base 4.2" sync radio/ non-amplified Stock Installed: Pioneer C2550NEX headunit Maestro RR (steering controls) Hertz K165 speakers component front /coaxial rear - Uses inline crossover capacitor Sky High Audio Triple shielded OFC RCAs (4ch & mono)...

Fair enough. They are being considerate, which they should for what we pay to do all this. Regardless I should research a bit more. To answer my own question it seems that it's possible to wire 2 4 ohm dvc subs to 1 ohm final load, just connect all positive and all negatives together.

Ok so I called the sound shop and they have a Diamond 1600 RMS at 1 ohm. My subs are 4 ohm so I assume I could run them at 1 ohm if wired properly? Unfortunately they didn't seem to mention this so

Understood. Hopefully my alternator can keep up, it is 130A I believe. I'll use appropriate wiring to the system and a power capacitor. Since I'm going this far money isn't really a limiting factor (which is dangerous when things cost a lot lol).

Gotcha, thank you so much for your input! I'll go ahead and look for 1500+, Kicker makes that 1800w that is cheaper than the JL. So I'll consider it. My sound shop is reputable but they are stuck on that cxa 1200 and I thought it was a bit strange since my subs are rated above it's output. But...

Hey I'm new to the forums. A bit new to car audio but this is not my first system. My goal is overall sound quality but also deep, hard hitting bass. Here is my current setup thus far but need to figure out the amp: Kenwood Excelon head unit 709s Kenwood Excelon speakers (Dual) Kicker...