Recent content by eliotz28

Thanks for your help. I think i will try the polyfill and a 3" aero port. Im already %40 over daytons recommendations. they recommend .47 cuft ported lol.

My port is complely external. Do you think I will have port noise with a 3 inch aero port? the subs have a low xmax (12mm) but i was worried about port noise so i went with the 4 inch. its interesting what you said about this being a burp box design because this thing is loud as fuxk at...

.08

Im pretty confident I have 1.35 after displacement the box has a small tumor on the side (for lack of a better word) for a little extra airspace. the sub displaces .08 cu a piece. I thought my problem was my head unit but switched to the 3800bhs and there was no change. General consensus on...

Whats your box's length x width x height Its a wedge enclosure bottom depth 10 inches top depth 6 inches 14 inches high 32 inches wide these are approximate measurements. the port is external, fires out the side and has 2 bends a 45 out the side and then a 90 down towards the corner. Where is...

I have 2 dayton ho 10 subwoofers in a 1.35 cu ft enclosure tuned to 28hz. My port is a piece of 4 inch pvc about 29 inches long. My issue is when playing low frequency's I have little to no output the subs are moving but there's very little sound. 50hz is loud 40 hz is half as loud 30hz is...

has anyone heard of this amplifier? does it do rated power? would it be a good amp to power some tweeters in an active setup?

the subs sound fine on the amp that's normally in there.

....in the trunk of a trade in. hooked it up and the low ohm light comes on when the bass hits and the subs make a terrible noise. seem to play ok at very low volume. any idea what could be wrong with this thing. fyi its wired at 2 ohms.

do either of those come in 6.75? i quick searched on google but all i saw was 6.5 right now i have a kac8452 bridged to 2 channels hpf at 90hz

So today i accidentally blew one of my pioneer 720prs midbass. Does anyone have any recommendations of a similar sounding set of 6.75 components. The only complaint i had with 720prs was that they were a bit lacking in output and the tweeter could be a bit harsh with some music. I have up to 200...

Im looking at running 2 RSS265HO dayton 10s in a behind the seat prefab box in my crew cab silverado work truck. The box is 1.8 cuft sealed and I wanted to add a 3 inch aero port to the side of the box tuned to 29hz. Is a 3 inch port too small for these subs? amp will either be a jl 1000/1 or a...

about 1/3 of the way up i have tried lowering and raising them.

i have a kicker zx650.4 that goes in and out of protect (ie amp powers up goes into protect turns off and then turns on and does the same thing again:verymad:) when the white rca is connected with only the red rca connected the amp works fine. my sub amp works fine with the same pair of rcas so...

pics?