Recent content by electropro

Ha , yeah I had a S-15 once that had electrical problems , It took me a while to find one small ground hooked to a loose dash mounting screw was the culprit. Tightend the screw and electrical problem solved. Def check factory grounds.

check out ma audio, bad little 8's fo da flo. Lots of haters out there tho. Ya dont have to be top doller to sound top doller...

Ace Hardware FTMFW... I am particular to the brass ones in a 10-24 configuration... 8 10-24's and your sub goes nowhere! Regular screws do/will vibrate loose over time I assure you:crap: And again Ace FTMFW...the local has a pretty extensive fastener/bolt selection

Heinz 57:confused::confused: It dont matter what race you are, if you aint gots no monies , it is all the same Fvcked up:(

Try to find yourself a more powerful amp. That x is hollerin for more power. Find a 1000 wrms that actually does 1000 or better and try it back in 1.5 cu. ft... you should notice an improvement from your previous trials:cool:

You will be just about right on with the brutus and x combo. Your x wont see 2000 watts rms, if it did I doubt it could last long enough to hurt the x. Just keep the gains at a decent level and it should be fine...

Another life ruined for some petty a$$ chit...because of a petty a$$ system...run by some petty a$$ persons...elected by some petty a$$ people...This is all just fvcking stoopid:furious::furious: WHAT THA Fvvvck?????????????????????

I use to bump a Jensen XS12, which cost fitty bucks at PepBoys. It was hooked up to old Audiovox amp. I built a spec wedge enclosure for it and I must say for what it was and what it cost, it sounded dam good. It surprised alot of people who had much more expensive equipment. I say go for it...

Kinda makes you wonder if he has an OEM amp, and if so, is he powering that up via the remote/p. antenna wire allowing signal to reach speakers? What vehicle???

Its all pink on the inside:D

If you are not worried about the lights dimming on the head unit, just hook the illumination wire from the head unit to the illumination wire on the car harness. If you want the head unit to dim, hook the illum. wire on h.u. to dimmer wire on car harness. *DO NOT CONNECT BOTH*. NOTE: Some head...

Human:cool: or atleast until the alien invasion!

I have used threaded wood inserts before, mine were made of brass though, came from Ace Hardware. They were through-bolt...Might consider some non permanent thread lock compound if your worried about air. Will help keep bolts from loosening with vibrations over time. I like them better than...

What sounds nice in my car, might sound like chit in yours:crazy: Adire= A+

How bout slammin your finger in an old school caddy door, that happened to be locked with windows up and find that the keys are in the house, and you cant get to them:laugh: