Recent content by Dustano

I just finished building my reg cab ported box for a 10. It is 2 cubes and tuned to 32 hz. On my amp i have 3 settings: level, subsonic filter and low pass filter. How do i set these? From what i think is right i put the subsonic filter at the same frequency that my box is tuned at because i...

i have an Autotek XS 1500.1 (1500 @ 1 ohm, 900 @ 2 ohm) What i meant to ask is would the 3 10 k'd be louder than 2 12 k's. 3 10's would prob be at 1.34 ohm, which is around 400-450 (give or take) each to the 10's and the 12's either 1 ohm or 2 ohm, prob 2 because they are only 350 rms. that...

you think 3 10 k's would be louder than my 2 12 8000's now?

i knew a guy who had it with no back, with 4 jl w0 10's. it sounded pretty good, i really want to go with 3 12 k's though. I have 2 Mtx 8000's right now in a 2.2 cu. ft but i want something a lot louder, 3.2 cu. ft and some poly-fill i think would be ok, but i still need that space .75" isn't...

lets say i go with 3 10's. I would then be able to maybe go with some se's. Around how much would 3 10 se's run?

ya well i'm more for the spl. so which would be better, 2 12's or 3 10's? keep in mind it is in a 2.83 cu. ft box and 2 12's i could run it at 1 ohm (1500 watts) with 3 tens it would only be at 1.34 ohm

what about the O's everyone always talks about the K's and the A's, if i was going to get 2 12's, i could go with the O's.

which is better for spl, 2 12 k's or 3 10 k's?

if i went with 3 would i run into any problems in the future with them?

i am looking at the ed k's and i want to put 3 of them in my truck, but i have limited space, the largest box i can fit is 2.83 cu. ft. Would that be enough for 3 or should i go with 2?

well it is in a single cab silverado, and i was to put 3 12 ed k's, without that .75" the biggest box i can make it 2.83 cu. ft. with that i can make it like 3.2 or something with would be a lot better for those subs. i knew a guy who had it and it wasn't bad, is there a way that i could seal...

why not? would it not sound right or what?

would it matter if i used the cab as the back of a box instead of a material, it would help out a lot in space if i could and If i did would i need to use some sort of sound dampening?

maximum i have 6 1/2 inches mounting debth, but even that is pushing it

i've heard a lot about Se's, but i don't know exactly what they are. Don't know anything about Hc's