Recent content by Dudebro241

I used a bolt under the seat and it seems fine. Amp runs nicely.

Should be but it doesn’t seem like it

I will see what it says tomorrow. What will this tell me though? If I check when it’s not running I will know if it leaks voltage but what about when it is running?

0 gauge wire. No big 3. Grounded under the rear seats. I’m just wondering if amps leak voltage when not on.   ---------- Post added at 09:37 PM ---------- Previous post was at 09:36 PM ----------   I will probably end up doing this

Just finished installing my system. It is a 15” soundqubed sub and a 1600.1 cab amp. After I hooked it all up I immediately started the Jeep and started playing music for maybe 5 minutes. Shut the Jeep off to see if it would start and it wouldn’t. Disconnected the amps power wire and it started...

Ok thank you

I need a ported box design for a hds315 (0.13 cu ft displacement) running at 1600 watts. What would be a good net volume as well as area and placement of port?

Are you talking about the big 3?

What’s the difference between the soundqubed hds315 and hds3.115? Can’t find any of the 315’s anywhere

So it’s safe to use that powerful of an amp on that soundqubed

Thanks for the help guys. The reviews look solid so I’m sold. That’s prolly what I will get.

I just want some nice crisp low thumps. I listen to hip hop and metal.

The sub would be wired at 2 ohms right? Is 1255 W gonna be enough for that sub?   ---------- Post added at 08:31 PM ---------- Previous post was at 08:30 PM ----------   I’ll prolly build my own.

Putting it in a grand Cherokee. Got plenty of space. Was checking out the soundqubed and cab. That setup looks awesome

I’m not sure. Which is better?